Originally Posted by MZ DAIZY That would be truly amazing if it turns out to be a washer. Unfortunately it wasn’t. I removed the switch from the console, and activated
|
|
LinkBack | Thread Tools | Display Modes |
08-25-2022, 12:32 PM | #61 (permalink) |
Base Member
Join Date: Apr 2022
Location: U.S.
Posts: 61
Drives: 19 Nissan 370Z CY M6
Rep Power: 3 |
Unfortunately it wasn’t. I removed the switch from the console, and activated it unmounted, clicked fine, still no go.
Such a mystery! Thanks
__________________
2019 370Z Sport Manual |
08-25-2022, 03:36 PM | #62 (permalink) |
Base Member
Join Date: Apr 2022
Location: U.S.
Posts: 61
Drives: 19 Nissan 370Z CY M6
Rep Power: 3 |
Problem is bad cluster
Well, dealer says it’s the cluster. It’s a Canadian vehicle. Was the cluster damaged upon the conversion from KM to Miles somehow?
Of course, Nissan won’t cover it, or even supply the U.S. dealer with the Canadian part number. They won’t allow a U.S. or Canadian cluster to be installed, WTF! The dealer isn’t recommending I install a U.S. cluster, they believe it will be an electrical issue. Does anyone have insight regarding this? Honestly, I’m not sure I agree with the assessment, have no idea though, I do like this service department. I’m only out $160 for diagnosis, if I’m going with a new cluster, it’s an easy diy, but would need the correct miles programmed. I just want Rev matching working, probably won’t use very much, but want my car functioning properly. Thanks for help! Update Don’t believe the cluster in my Z is the original one. It appears to be a U.S. cluster, believe it was swapped in. MPH are in large white numbers, not KM/H. Plus, there’s an old inventory sticker attached to it, probably from a recycled yard. My car is only 3 years old, shouldn’t have an old faded sticker anywhere. There’s no signs of this being any sort of salvaged car, body and interior are flawless, no signs of bodywork. Only feature not working is the Rev Matching. I’ve already road tripped it, drives perfectly! They probably swapped with U.S. cluster after taking in inventory. So maybe it’s the cluster after all?
__________________
2019 370Z Sport Manual Last edited by photoguy007; 08-25-2022 at 06:29 PM. |
08-26-2022, 04:40 PM | #63 (permalink) |
Track Member
Join Date: Jan 2017
Location: Vancouver, BC
Posts: 760
Drives: 17' 370Z Nismo
Rep Power: 40617 |
I was always insisting on wiring issue. Not sure if they actually dug into it per the FSM I posted for you.
Its a switch! Power, ground and signal to ecm. If cluster is bad, it's not the actual cause. Its just not providing one of those 3 things. In other words, shouldn't matter if Canadian or US cluster. Its just dial markings. Everything else is just signal. Does ECM care how fast you going...YES. Does it care if you are doing KMH or MPH? Don't know, but it's just a conversion so both the same really. |
08-26-2022, 05:04 PM | #64 (permalink) | |
Track Member
Join Date: Jun 2020
Location: Toronto
Posts: 716
Drives: Red '18 Sport Manual
Rep Power: 23498 |
Quote:
i can't think of any reason they would use different canbus ids across regions. |
|
08-26-2022, 06:49 PM | #65 (permalink) |
Track Member
Join Date: Mar 2015
Location: Michigan
Posts: 549
Drives: 370Z Nismo
Rep Power: 9469 |
If the N is flashing it then it probably just needs a neutral position relearn and you can definitely do that by yourself, no need to give it to some stupid techs at the stealerships.
__________________
Creator of the GTR TT Conversion Kit, NA Record Holder (401WHP) Ecutek Master Tuner (VQ37, VR30, VR38, B58, S55, S58) BTWTuning |
08-26-2022, 09:58 PM | #66 (permalink) |
Track Member
Join Date: Jan 2017
Location: Vancouver, BC
Posts: 760
Drives: 17' 370Z Nismo
Rep Power: 40617 |
From FSM:
"SYSTEM DESCRIPTION Refer to Owner's Manual for SynchroRev Match mode (S-MODE) operating instructions. SynchroRev Match mode (S-MODE) controls engine speed at a suitable level from the present to the next gear position. This control is switched by S-MODE switch (Refer to EC-531, " Description"). When clutch pedal is depressed and shift lever is shifted while S-MODE is being operated, gear position signal is sent to ECM. ECM calculates target engine speed by gear position signal and vehicle speed signal, and then controls throttle opening angle and ignition timing. When downshift is performed, even if accelerator pedal is not depressed, ECM automatically controls throttle opening angle and increases engine speed. When upshift is performed, ECM controls engine speed so that it does not drop lower than the necessary level that is required after upshifting. Engine speed is controlled according to shifting operation above and driver can perform shifting operation quickly, smoothly, and without shifting shock. When S-MODE malfunction is detected, S-MODE warning on information display illuminates and S-MODE is automatically cancelled. At this time, S-MODE indicator turns OFF." Last edited by ZoomZ; 08-26-2022 at 10:22 PM. |
08-26-2022, 10:10 PM | #67 (permalink) |
Track Member
Join Date: Jan 2017
Location: Vancouver, BC
Posts: 760
Drives: 17' 370Z Nismo
Rep Power: 40617 |
The signal from combination meter vehicle speed to ECM is via CAN BUS and subsequently, s-mode shift position indicator to combination meter is also CAN BUS.
If there is a short on the CAN BUS, you will have other failures. You do not show any of that. (ie: Tachometer not working or shift position indicator blank) NOt to say the cluster ( Combination meter) cannot be faulty. I just read the very first post where you say you got a $1500 discount in lieu for the meter replacement. Sounds like you got the wrecker special, full of water and probably internal corrosion or bent pins etc. You also say you have a sport model. I think someone stole your cluster and replaced with non-sport or one without rev matching pin-outs. They didn't even bother to check the markings for the country. I'm guessing this last dealer may have done the proper T/S to determine your wires are ok. Hence the diagnosis of bad Combo meter. But what puzzles me is, this dealer should have realized what pin-outs are on the back of combo meter that supports the Harness in your car. Last edited by ZoomZ; 08-26-2022 at 10:20 PM. |
08-26-2022, 10:27 PM | #68 (permalink) | |
Track Member
Join Date: Jun 2020
Location: Toronto
Posts: 716
Drives: Red '18 Sport Manual
Rep Power: 23498 |
Quote:
and the trans does not send gear position can messages iirc seems like: gear position works wheel speed works if you have a flashing n when you press the button then the switch works but sounds like you have no flashing N the switch is new (possible it came broken, don't rule that out) or the switches wiring is messed up. Time to get out a multimeter. and test those wires. Last edited by SeeThruHead; 08-26-2022 at 10:34 PM. |
|
08-27-2022, 02:28 AM | #70 (permalink) | |
Base Member
Join Date: Apr 2022
Location: U.S.
Posts: 61
Drives: 19 Nissan 370Z CY M6
Rep Power: 3 |
Quote:
Here’s the official diagnosis (below). I also discovered “Useable Auto Parts” in Canada. They specialize in recycled Nissan and Infinity parts, kinda lucked out there. I’m just going to purchase the appropriate cluster, they have a low miles one for $250. If the appropriate cluster is indeed the issue, no major issue, I’m only out a few bucks. Plus, I actually would like a KM/H cluster. I’ll keep everyone updated, once my cluster gets here, will probably be a week or two going through customs. Extremely grateful for all the help from everyone!!! Thank you!!! OFFICIAL DIAGNOSIS 83F7DBD1-EEA6-4A05-89AB-A8584CF31237.jpg
__________________
2019 370Z Sport Manual |
|
08-27-2022, 02:34 AM | #71 (permalink) |
Base Member
Join Date: Apr 2022
Location: U.S.
Posts: 61
Drives: 19 Nissan 370Z CY M6
Rep Power: 3 |
[QUOTE=SeeThruHead;4029150]non sport dash doesn't have a gear position indicator.
and the trans does not send gear position can messages iirc seems like: gear position works wheel speed works if you have a flashing n when you press the button then the switch works but sounds like you have no flashing N the switch is new (possible it came broken, don't rule that out) or the switches wiring is messed up. Here’s the diagnosis. Thanks a ton!! DDC3A604-B9D7-4E2E-8780-2134AD0F9267.jpg
__________________
2019 370Z Sport Manual |
08-27-2022, 12:05 PM | #73 (permalink) | |
Track Member
Join Date: Jan 2017
Location: Vancouver, BC
Posts: 760
Drives: 17' 370Z Nismo
Rep Power: 40617 |
Quote:
Not surprising that Nissan would leave gear Position indicator out for non-sport. I'm a late model Nismo and not familiar with internal features of other models. I would be very interested to see if the "window" for gear position is still installed, just not lit up. Oh Nissan. |
|
08-27-2022, 01:47 PM | #74 (permalink) |
Base Member
Join Date: Apr 2022
Location: U.S.
Posts: 61
Drives: 19 Nissan 370Z CY M6
Rep Power: 3 |
They even discounted the $160 a little. Synthetic oil change and diagnosis for $200, I do actually like their service department, total opposite of the previous dealer disaster.
__________________
2019 370Z Sport Manual |
09-12-2022, 01:01 PM | #75 (permalink) | |
Base Member
Join Date: Feb 2021
Location: california
Posts: 32
Drives: 370z MR M6
Rep Power: 195 |
Quote:
Yes, dealers are hit and miss, the care of your car in their property is never #1 priority. |
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
S mode not working at all | JamesTheBrain | Engine & Drivetrain | 33 | 10-14-2020 01:21 PM |
S-Mode stopped working for a while??? | red6spd | Nissan 370Z General Discussions | 28 | 07-02-2018 01:37 PM |
Help!!! Air conditioner and Sport Mode not working!!! | Dragon_Ball_Z | Exterior & Interior | 45 | 04-24-2015 03:25 PM |
Any harm to switching from auto mode 'D' to manual mode and back while driving? | Lee123 | Engine & Drivetrain | 14 | 05-19-2010 08:10 PM |