What did you do with your Z today V (ON TOPIC DISCUSSION ONLY)

BettyZ · 06-13-2019, 12:31 PM

Quote:

Originally Posted by mishuko

Manual says get car to operating temps. Let it sit for iirc 15min then check

Yea i open up first and second all the time on my dd if i get the chance

Quote:

Originally Posted by Rusty

I lost count on how many times mine has been bounced off of the rev limiter.

Good to know I haven't busted something important. Checked the oil immediately after running errands so car was warm. Still wondering where oh where all that oil disappeared to lol

-ZS-Carpenter · 06-13-2019, 12:40 PM

I lose some oil when I run it hard. It's mostly from blow by I'm guessing since I got no leaks and no blue smoke.

Sent from my SM-G965U using Tapatalk

mishuko · 06-13-2019, 12:43 PM

Quote:

Originally Posted by Ghostvette

Previous advise applies....

I did... this is the definition of insanity

Quote:

Originally Posted by BettyZ

Good to know I haven't busted something important. Checked the oil immediately after running errands so car was warm. Still wondering where oh where all that oil disappeared to lol

Odd.... and obvious question but were you on an incline?

Quote:

Originally Posted by -ZS-Carpenter

I lose some oil when I run it hard. It's mostly from blow by I'm guessing since I got no leaks and no blue smoke.

Sent from my SM-G965U using Tapatalk

I noticed on my old z after 5000 km oil started to drop slowly (i check every fuel up)

New car havent noticed that. It was a bit lower last fuel up but i think engine was still draining as it was only 1/3tank. Aslong as its above l and helow h dots we good.

I spool out the engine A LOT

Rusty · 06-13-2019, 01:18 PM

Quote:

Originally Posted by BettyZ

Good to know I haven't busted something important. Checked the oil immediately after running errands so car was warm. Still wondering where oh where all that oil disappeared to lol

The heads hold a lot. It takes a little while for the oil to drain back down. And to drip off of everything.

MZ DAIZY · 06-13-2019, 02:46 PM

Quote:

Originally Posted by bettyz

wrapped both sides of the y pipe. Miserable experience even with the wrapping pre-soaked. Going to take a 30 minute shower/decon and get this fiberglass off my ******* skin

sent from my sm-g955u using tapatalk

nice!!!!

BettyZ · 06-13-2019, 05:45 PM

Can anyone tell me why I have to keep the screw aroused during installation? I know the Japanese can be weird AF but this us a whole another level of strange..

Sent from my SM-G955U using Tapatalk

-ZS-Carpenter · 06-13-2019, 05:54 PM

Quote:

Originally Posted by mishuko

I did... this is the definition of insanity

Odd.... and obvious question but were you on an incline?

I noticed on my old z after 5000 km oil started to drop slowly (i check every fuel up)

New car havent noticed that. It was a bit lower last fuel up but i think engine was still draining as it was only 1/3tank. Aslong as its above l and helow h dots we good.

I spool out the engine A LOT

I don't lose any just driving it around on the street. It take a beating to see oil loss. Only time I see it is at the 1/2 mile event. But I'm running it up 7600+(limiter set at 7800) in every gear for 50~ runs over 2 dayz using everything ARC has to offer every run.

Sent from my SM-G965U using Tapatalk

-ZS-Carpenter · 06-13-2019, 05:55 PM

Quote:

Originally Posted by BettyZ

Can anyone tell me why I have to keep the screw aroused during installation? I know the Japanese can be weird AF but this us a whole another level of strange..

Sent from my SM-G955U using Tapatalk

Well you sure dont want it to lose interest

Sent from my SM-G965U using Tapatalk

hustleman222 · 06-13-2019, 07:47 PM

I finally installed my carbon signal rear diffuser for the 15+ nimso...I have been putting it off because I wanted to have it flush, but ended up getting motivated and installed with 1" spacers. I'm so happy the whole lip kit is now installed.

Hot Rod 370 Z · 06-13-2019, 10:16 PM

Diffuser looks good. I finally ordered Sprint Booster today. Should arrive early next week. Was able to get a 10% discount. Hot Rod Z

Ian B · 06-14-2019, 02:45 AM

pedal commander arriving today.

BettyZ · 06-14-2019, 05:03 AM

Went out for a paltry 325 mile spin along the Mississippi River.. they built a new bridge at Savanna/Sebula, and since I've already crossed near all the bridges over the Mississippi i was like "oh! this opportunity comes across once every 10 years or so.. gotta action it." Did so and completed some unfinished parts of the Lincoln Highway National Scenic Byway on the way back.

Brought with a temp gun; am pleased to report to the forum that after wrapping my Y-pipe, readings of the floor pan/trans hump never exceeded 89*F during a 7 hour somewhat-spirited drive with ambient temps ranging from 70*F to 50*F. Sadly, I don't have temp readings from before I wrapped the pipe; that being said, the passenger compartment was noticeably cooler. A box of wrap costs $15 on Amazon. This mod is very high on the cost/benefit curve, and I recommend you do it.

Sway · 06-14-2019, 05:33 AM

Thanks for the update Betty! I’m going to have to do this!

Zingston · 06-14-2019, 06:42 AM

Quote:

Originally Posted by Sway

Thanks for the update Betty! I’m going to have to do this!

CRiZO · 06-14-2019, 07:25 AM

Quote:

Originally Posted by BettyZ

Went out for a paltry 325 mile spin along the Mississippi River.. they built a new bridge at Savanna/Sebula, and since I've already crossed near all the bridges over the Mississippi i was like "oh! this opportunity comes across once every 10 years or so.. gotta action it." Did so and completed some unfinished parts of the Lincoln Highway National Scenic Byway on the way back.

Brought with a temp gun; am pleased to report to the forum that after wrapping my Y-pipe, readings of the floor pan/trans hump never exceeded 89*F during a 7 hour somewhat-spirited drive with ambient temps ranging from 70*F to 50*F. Sadly, I don't have temp readings from before I wrapped the pipe; that being said, the passenger compartment was noticeably cooler. A box of wrap costs $15 on Amazon. This mod is very high on the cost/benefit curve, and I recommend you do it.

What is that HUD?

06-13-2019, 05:45 PM	#3486 (permalink)
BettyZ A True Z Fanatic Join Date: Aug 2018 Location: Chicagoland Age: 38 Posts: 5,261 Drives: A Garage Queen Rep Power: 2684371	Can anyone tell me why I have to keep the screw aroused during installation? I know the Japanese can be weird AF but this us a whole another level of strange.. Sent from my SM-G955U using Tapatalk MadSciSnails likes this. __________________ '14 MB Nismo \| Boost Lab 6870 1.32 AR 553 HP / 471 ft.-lbs. Betty Mods

06-13-2019, 10:16 PM	#3490 (permalink)
Hot Rod 370 Z Base Member Join Date: Oct 2018 Location: Florida Posts: 88 Drives: 2016 Z51 Vette Rep Power: 5873	Diffuser looks good. I finally ordered Sprint Booster today. Should arrive early next week. Was able to get a 10% discount. Hot Rod Z BettyZ likes this.

06-14-2019, 05:03 AM	#3492 (permalink)
BettyZ A True Z Fanatic Join Date: Aug 2018 Location: Chicagoland Age: 38 Posts: 5,261 Drives: A Garage Queen Rep Power: 2684371	Went out for a paltry 325 mile spin along the Mississippi River.. they built a new bridge at Savanna/Sebula, and since I've already crossed near all the bridges over the Mississippi i was like "oh! this opportunity comes across once every 10 years or so.. gotta action it." Did so and completed some unfinished parts of the Lincoln Highway National Scenic Byway on the way back. Brought with a temp gun; am pleased to report to the forum that after wrapping my Y-pipe, readings of the floor pan/trans hump never exceeded 89F during a 7 hour somewhat-spirited drive with ambient temps ranging from 70F to 50*F. Sadly, I don't have temp readings from before I wrapped the pipe; that being said, the passenger compartment was noticeably cooler. A box of wrap costs $15 on Amazon. This mod is very high on the cost/benefit curve, and I recommend you do it. Rusty, Hotrodz, Sway and 4 others like this. __________________ '14 MB Nismo \| Boost Lab 6870 1.32 AR 553 HP / 471 ft.-lbs. Betty Mods

06-14-2019, 05:33 AM	#3493 (permalink)
Sway Track Member Join Date: Sep 2012 Location: TX Posts: 697 Drives: 2018 GTR Rep Power: 37871	Thanks for the update Betty! I’m going to have to do this! Zingston and BettyZ like this. __________________ - White 2018 GTR FBO+E85 - Check out my old build thread: Sway’s Journal-Hitomi ~Live and let live!~

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[MAZOC] Official "Off-Topic" Discussion Thread	m4a1mustang	MAZOC	6670	09-06-2018 07:21 PM
What did you do with your Z today VI (ON TOPIC DISCUSSION ONLY)	AK370Z	Nissan 370Z General Discussions	10007	06-08-2017 09:48 AM
The New "What did you do with your Z today" (with off topic replies) XVIV	eastwest2300	The Lounge (Off Topic)	10005	09-11-2015 08:57 AM
What did you do with your Z today V (ON TOPIC DISCUSSION ONLY)	AK370Z	Nissan 370Z General Discussions	10148	06-19-2014 08:20 PM
The New "What did you do with your Z today" (with off topic replies) VIII	JARblue	The Lounge (Off Topic)	10016	11-10-2013 11:21 AM

06-13-2019, 12:40 PM	#3482 (permalink)
-ZS-Carpenter A True Z Fanatic Join Date: Sep 2016 Location: Illinois Posts: 2,410 Drives: 13 370z 6MT Rep Power: 2684367	I lose some oil when I run it hard. It's mostly from blow by I'm guessing since I got no leaks and no blue smoke. Sent from my SM-G965U using Tapatalk

06-14-2019, 02:45 AM	#3491 (permalink)
Ian B Track Member Join Date: Mar 2011 Location: Cedar Park Posts: 679 Drives: 2010 Nissan Rep Power: 137466	pedal commander arriving today.