What did you do with your Z today V (ON TOPIC DISCUSSION ONLY)

Lvcky69 · 12-16-2018, 12:39 AM

took a pic of bae while visiting the fam

ChopsZ · 12-16-2018, 12:45 AM

Still battling this damn suspension creaking, rattling and clunking in the rear. So today, we cut some 0.25" heavy industrial rubber pads and installed them on the spring perches. Took it out for a spin, and... STILL RATTLING AND CLUNKING!!! Dammit! The creaking is pretty much gone though, so not a total loss I guess.

And yes, just as twice before, we have checked, double checked and triple checked all suspension points in the rear. Everything is torqued to spec, and checked again.

The only other thing I can think of it being is the top hats of the rear BC BR shocks being shot or the shocks themselves being shot. But as far as operation goes, the shocks are working fine and respond well to stiffness adjustments.

All I know is that this damn continuing noise is really starting to piss me off.

On a slightly brighter note, since the rear wheels were already off the car, we pulled the fronts off as well, thoroughly cleaned and scrubbed the backsides of them as well as the faces of them, remounted them, dried them and the tires, and then applied a healthy dose of Meguiar's #40 vinyl/rubber cleaner and conditioner. Made the tires look brand new again. Not that nasty, ugly shiny crap.

Oh, and lastly, I bumped up the stiffness slightly on the shocks front and rear. The fronts are set to 25 to stiff, the rears are 21 to stiff. Before, all four were at 15 (out of a total of 31).

old guy · 12-16-2018, 08:25 AM

ChopZ,
Is the differential bushing intact ?

ChopsZ · 12-16-2018, 10:39 AM

Quote:

Originally Posted by old guy

ChopZ,
Is the differential bushing intact ?

I certainly hope so. The car just turned over 16k miles and is only 2.5 years old. I mean, I drive my car hard, but I don't spin the tires or make them hop. I would think that sort of recklessness would cause that particular bushing to go this soon.

However, with all of that being said, I honestly never even looked up there at it to see. I'll go out take a quick peek under there in a few. If I see a bunch of black puke running down the differential housing, I'll know it's shot.

Hotrodz · 12-16-2018, 10:54 AM

Quote:

Originally Posted by ChopsZ

I certainly hope so. The car just turned over 16k miles and is only 2.5 years old. I mean, I drive my car hard, but I don't spin the tires or make them hop. I would think that sort of recklessness would cause that particular bushing to go this soon.

However, with all of that being said, I honestly never even looked up there at it to see. I'll go out take a quick peek under there in a few. If I see a bunch of black puke running down the differential housing, I'll know it's shot.

I think there is a thread in the Brakes and Suspension section on rear axle clunk and how to fix it. That may be your issue. Mine has been clunking for a while and I am sure that is what it has to be as I have changed out every bushing possible in the rear suspension and I am running on true type coilovers.

Sent from my SM-G965U using Tapatalk

ChopsZ · 12-16-2018, 01:09 PM

Just took another look under the car a bit ago and the diff cover is spotless, so I'm pretty sure the diff bushing isn't shot or leaking.

Quote:

Originally Posted by Hotrodz

I think there is a thread in the Brakes and Suspension section on rear axle clunk and how to fix it. That may be your issue. Mine has been clunking for a while and I am sure that is what it has to be as I have changed out every bushing possible in the rear suspension and I am running on true type coilovers.

Sent from my SM-G965U using Tapatalk

I don't think that is my issue here. It only started immediately after installing the coilovers. There were zero noise issues before pulling into the shop to install the coilovers, but the noise issue was definitely there right after getting the car off the lift after the install.

And even after I took the car to the alignment shop to have the alignment done, he inspected everything and double checked the torque on everything as well for me. He even pulled the rear shocks, adjusted them and reinstalled them. Even he couldn't figure out what was causing the noise.

With all of the high end Porsche's, Lambo's, etc, etc and race cars he works on, I highly trust him with my car, which is exactly why I drive the 100 miles or so to have him do my alignments. He knows his shizz.

Hotrodz · 12-16-2018, 02:08 PM

Quote:

Originally Posted by ChopsZ

Just took another look under the car a bit ago and the diff cover is spotless, so I'm pretty sure the diff bushing isn't shot or leaking.

I don't think that is my issue here. It only started immediately after installing the coilovers. There were zero noise issues before pulling into the shop to install the coilovers, but the noise issue was definitely there right after getting the car off the lift after the install.

And even after I took the car to the alignment shop to have the alignment done, he inspected everything and double checked the torque on everything as well for me. He even pulled the rear shocks, adjusted them and reinstalled them. Even he couldn't figure out what was causing the noise.

With all of the high end Porsche's, Lambo's, etc, etc and race cars he works on, I highly trust him with my car, which is exactly why I drive the 100 miles or so to have him do my alignments. He knows his shizz.

Right on, not questioning your shop, just proving information. Stranger things have happened.

Sent from my SM-G965U using Tapatalk

Spooler · 12-16-2018, 02:18 PM

Did you set the preload via the shock length? Example: you jack up the car under the spring perch, it should compress only 1/2 in. or so before it lifts the car of the jack stand it was sitting on. You only do this for the rear.

ChopsZ · 12-16-2018, 02:41 PM

Quote:

Originally Posted by Hotrodz

Right on, not questioning your shop, just proving information. Stranger things have happened.

Sent from my SM-G965U using Tapatalk

Nah, you're good. I wasn't think that at all.

ChopsZ · 12-16-2018, 02:42 PM

Quote:

Originally Posted by Spooler

Did you set the preload via the shock length? Example: you jack up the car under the spring perch, it should compress only 1/2 in. or so before it lifts the car of the jack stand it was sitting on. You only do this for the rear.

Yup.

You did just fully read my post right above, right?..

blackcherry20 · 12-16-2018, 06:41 PM

Admired the lines under the cover.

NorthStyle · 12-17-2018, 07:50 AM

Cleaned up a bit of wiring and installed the new dash pieces to replace my previous headunit

ColtronZ · 12-17-2018, 09:24 AM

Really was not wanting to change my oil, but enjoyed it once I started. Kind of therapeutic. Plus I may have changed my oil 1k miles before my usual 5k. Oh well.

JARblue · 12-17-2018, 11:24 AM

Been thinking I should buy a CJ Motorsports billet top hat for my fuel pump assembly since mine broke last year. Just bought a used CJM Road Race Pump kit from a fellow forum member instead.

abm89 · 12-17-2018, 04:09 PM

I went to cars and coffee Sunday. Was the first time I drove the Z since buying a daily.

Also, Meguiars tire gel is very nice. Has the right amount of shine and my garage smells like berries.

12-16-2018, 12:39 AM	#2521 (permalink)
Lvcky69 Enthusiast Member Join Date: Jun 2017 Location: Miami Posts: 385 Drives: 17 370z & 16 911 S Rep Power: 3922	took a pic of bae while visiting the fam loiro370z, envisous and SRJ like this. Last edited by Lvcky69; 12-16-2018 at 12:43 AM.

12-16-2018, 12:45 AM	#2522 (permalink)
ChopsZ Track Member Join Date: May 2016 Location: Central Florida Age: 49 Posts: 965 Drives: 2016 370Z GM 6MT Rep Power: 2301	Still battling this damn suspension creaking, rattling and clunking in the rear. So today, we cut some 0.25" heavy industrial rubber pads and installed them on the spring perches. Took it out for a spin, and... STILL RATTLING AND CLUNKING!!! Dammit! The creaking is pretty much gone though, so not a total loss I guess. And yes, just as twice before, we have checked, double checked and triple checked all suspension points in the rear. Everything is torqued to spec, and checked again. The only other thing I can think of it being is the top hats of the rear BC BR shocks being shot or the shocks themselves being shot. But as far as operation goes, the shocks are working fine and respond well to stiffness adjustments. All I know is that this damn continuing noise is really starting to piss me off. On a slightly brighter note, since the rear wheels were already off the car, we pulled the fronts off as well, thoroughly cleaned and scrubbed the backsides of them as well as the faces of them, remounted them, dried them and the tires, and then applied a healthy dose of Meguiar's #40 vinyl/rubber cleaner and conditioner. Made the tires look brand new again. Not that nasty, ugly shiny crap. Oh, and lastly, I bumped up the stiffness slightly on the shocks front and rear. The fronts are set to 25 to stiff, the rears are 21 to stiff. Before, all four were at 15 (out of a total of 31). __________________ She's For Sale! PERFORMANCE: Aero Workz \| Akebono \| BC Racing \| EcuTek \| HKS \| MaxBore \| Motordyne \| Nismo \| RJM \| SPL \| StopTech \| Z1 AUDIO: Arc Audio \| Bazooka \| Helix \| Pioneer \| Stereo Integrity

12-16-2018, 08:25 AM	#2523 (permalink)
old guy A True Z Fanatic Join Date: Apr 2015 Location: S.E. Michigan Age: 68 Posts: 2,707 Drives: 13 magma touring Rep Power: 2684369	ChopZ, Is the differential bushing intact ? ChopsZ likes this. __________________ I better walk before they make me run....

12-16-2018, 06:41 PM	#2531 (permalink)
blackcherry20 A True Z Fanatic Join Date: May 2012 Location: Southern Ohio Posts: 22,749 Drives: ‘17 badazz Z51 Rep Power: 240459	Admired the lines under the cover. JARblue and axmea? like this. __________________ Grand Sport Corvette Arctic White

12-17-2018, 07:50 AM	#2532 (permalink)
NorthStyle A True Z Fanatic Join Date: Aug 2015 Location: Deutschland + SC/FL USA Posts: 1,255 Drives: 2011 370Z Nismo Rep Power: 24277	Cleaned up a bit of wiring and installed the new dash pieces to replace my previous headunit Hotrodz, Over_ReV and JTM88 like this.

12-16-2018, 02:18 PM	#2528 (permalink)
Spooler A True Z Fanatic Join Date: Jun 2014 Location: Ga Posts: 13,780 Drives: 2013 Nismo 370z Rep Power: 2684392	Did you set the preload via the shock length? Example: you jack up the car under the spring perch, it should compress only 1/2 in. or so before it lifts the car of the jack stand it was sitting on. You only do this for the rear.

12-17-2018, 09:24 AM	#2533 (permalink)
ColtronZ Enthusiast Member Join Date: Jan 2018 Location: Tampa, FL Posts: 310 Drives: 17 370z Rep Power: 6295	Really was not wanting to change my oil, but enjoyed it once I started. Kind of therapeutic. Plus I may have changed my oil 1k miles before my usual 5k. Oh well.

12-17-2018, 11:24 AM	#2534 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	Been thinking I should buy a CJ Motorsports billet top hat for my fuel pump assembly since mine broke last year. Just bought a used CJM Road Race Pump kit from a fellow forum member instead. cv129 and Hotrodz like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

12-17-2018, 04:09 PM	#2535 (permalink)
abm89 A True Z Fanatic Join Date: Feb 2013 Location: Austin, Texas Posts: 1,382 Drives: 11 370Z \| 24 EL450 Rep Power: 64763	I went to cars and coffee Sunday. Was the first time I drove the Z since buying a daily. Also, Meguiars tire gel is very nice. Has the right amount of shine and my garage smells like berries. God-Speed, Rusty and Hotrodz like this. __________________ Complete Parts List: https://github.com/abm89/ztouge-build

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[MAZOC] Official "Off-Topic" Discussion Thread	m4a1mustang	MAZOC	6670	09-06-2018 08:21 PM
What did you do with your Z today VI (ON TOPIC DISCUSSION ONLY)	AK370Z	Nissan 370Z General Discussions	10007	06-08-2017 10:48 AM
The New "What did you do with your Z today" (with off topic replies) XVIV	eastwest2300	The Lounge (Off Topic)	10005	09-11-2015 09:57 AM
What did you do with your Z today V (ON TOPIC DISCUSSION ONLY)	AK370Z	Nissan 370Z General Discussions	10148	06-19-2014 09:20 PM
The New "What did you do with your Z today" (with off topic replies) VIII	JARblue	The Lounge (Off Topic)	10016	11-10-2013 12:21 PM