Tada.
http://uploads.tapatalk-cdn.com/2016...3ee07b623c.jpg

:tup:

..also..JAPANPOWER :rock:

Damn! I just put in iJDMTOY rear fog light but luckily mine isn't a Nismo.

Nice work!

https://farm2.staticflickr.com/1538/...b68acf_z_d.jpg

https://farm2.staticflickr.com/1637/...d6fb9d_z_d.jpg

Very nice love PW on a Z

Say it ain't so... Nismo Foglight Install
 

Those aren't for the Z but yeah love me some Rays... Those are on the DD.

http://uploads.tapatalk-cdn.com/2016...6944bc2696.jpg

http://uploads.tapatalk-cdn.com/2016...afcc672936.jpg

dogdamn, u haz two nismos? :tup:

fak we all failed.. :mad:

Long story... Had a 2011 PW ST and put about 90K on it quick. Traded that for the Juke RS and missed the Z everyday. Found a deal on the Nismo Z that I just couldn't pass up.

I was wondering the same since mine is empty too.

wallet or..?

Thanks for this thread.. I was thinking of getting a fog light for my Nismo but dang I'm not about to take off my bumper just for a light. You saved me some $$$ buddy!


Sent from my iPhone using Tapatalk

Say it ain't so... Nismo Foglight Install
 

Your welcome...

I wouldn't say it's impossible to do the install without removing the bumper, but with the visibility and the additional bracing and angles in the area where the fog goes I had just had enough.

Steps are just:
1. Remove interior trunk panels
2. Remove taillights
3. Passenger side bumper 2 bolts 2 push pins
4. Drivers side 1 bolt 2 push pins
5. Underneath 2 bolts 6 push pins
6. Carefully remove bumper with placing something to support the bumper if doing it alone

That's pretty much it. Don't doubt it... Do it!
http://uploads.tapatalk-cdn.com/2016...53e8c0ebf0.jpg

How was getting the nut and bolts on the fake fog light off? I've read it's a pain because it spins or rusts together and some people have to cut it off


Sent from my iPhone using Tapatalk

I've been very lucky and haven't had that issue.. I have heard that though.

This is the 3rd one I've done and I've found the following helps:

Leave the car parked with the rear facing the sun for a couple hours. Then if possible use a combination wrench on the nut. Counter clockwise slow even pressure. Probably the stripping issue comes from just forcing it thus gouging the plastic where the bolt seats in the housing.

You can also soak the nut in acetone or penetrating oil I've heard that too.

wat? taking off the bumper is easy. just do it. :tup:

i need to do the foglamp on my STI..

Yeah pretty straight forward getting over the mental aspect of "I'm taking off the bumper of my 40 thousand dollar car to install a 60 dollar light?" Is the real struggle ;)