Rev in Red zone

Supremo · 10-24-2009, 04:58 PM

...however the interval I have seen it there was very short. Maybe half a second or less.

cjof2003 · 10-24-2009, 05:24 PM

500rpms over the redline probably won't cause any issues.
I don't know how the 370z motor is, but if it went past 8k you could bend a valve, bend a rod or a number of other issues.

ChrisSlicks · 10-24-2009, 05:26 PM

Quote:

Originally Posted by cjof2003

500rpms over the redline probably won't cause any issues.
I don't know how the 370z motor is, but if it went past 8k you could bend a valve, bend a rod or a number of other issues.

If it was under load you could definitely bend something, but if you're downshifting then it shouldn't be under much load.

jookiyaya · 10-24-2009, 10:47 PM

of course thats bad. thats what i did to my type R and ended up ruining my syncros which causes grinding in 3rd. i had to replace the rings which the body shop did a crappy job of when they had to open up my transmission and it was never the same since.... so be careful ^_^

10-24-2009, 10:47 PM	#4 (permalink)
jookiyaya Enthusiast Member Join Date: Jul 2009 Location: maryland Posts: 262 Drives: 2010 40th Z!?!? Rep Power: 16	of course thats bad. thats what i did to my type R and ended up ruining my syncros which causes grinding in 3rd. i had to replace the rings which the body shop did a crappy job of when they had to open up my transmission and it was never the same since.... so be careful ^_^ __________________ "370z gives you wings!! "

10-24-2009, 04:58 PM	#1 (permalink)
Supremo Base Member Join Date: Oct 2009 Location: Hungary Posts: 14 Drives: NIssan -2009 - 370Z Rep Power: 16	...however the interval I have seen it there was very short. Maybe half a second or less.

10-24-2009, 05:24 PM	#2 (permalink)
cjof2003 Base Member Join Date: Sep 2009 Location: Atlanta, GA Posts: 74 Drives: 02 Acura RSX Type S Rep Power: 16	500rpms over the redline probably won't cause any issues. I don't know how the 370z motor is, but if it went past 8k you could bend a valve, bend a rod or a number of other issues.