Floor lighting
 

Does anyone know where to tap in to the dome light wiring under the dash for floor lighting? I searched on line and couldn't find anything. I just want the basic door open lights are one, doors closed lights are off. I added LED's to the dome light today and want to add the floor lighting also.

Look in the DIY forum for lighted kick plate install. There is a fuse box in the passenger side that is taped for that purpose.

Good deal, thanks for your help.

This uses a harness to the BCM, not the fuse box...

I ended up going right to the ribbon wire in the dome light assembly when I did mine.

I ended up just tapping into the sill plates on each side of the car. I took a picture incase someone ever wanted to do the same. When I took the drivers side apart and seen the cable I checked it at the fuse box and the two cables can easily be tapped into at the box also. Since I already had the drivers side apart I just decided to add it there.

I did similar, I think?...

I tapped in to the door sill lights and grounded at the door pin switch for the puddle lights and reflector lights

http://i7.photobucket.com/albums/y26...psrntjyaoz.jpg

http://i7.photobucket.com/albums/y26...pshcsqxr0u.jpg

Also if you get interested, It's pretty easy to do foot board lights and under the door cards... I tapped into the illuminated hazard light button and used any grounding points I can find.

(crappy cell phone pictures, but it lights up all the pedals [and it's not quite dark outside so light is still shining through the 4 garage windows])
http://i7.photobucket.com/albums/y26...pss6rmhogs.jpg

I really want this done. I am afraid to do this myself.