V1H

Hey - also just asking about your DIY: Aftermarket Seats Installation post. Regarding the passenger occupancy sensor, I'm interested in going with your switch method and my understanding is the sensor has the IGN, GND & COM, and I should be wiring the IGN and GND, to switch's 12V and GND wires respectively, but for COM, I connect it to a 2-wire lead (one with 15 Ω, and other blank) to the switch's power/device wire - is this correct?


Thanks in advance.

Hey, I was trying to bypass my seat sensor based on your braum install thread. The photos seem to be lost, so I only had your text to go on. Did you have a seat connector with 3 wires to it? (12v, com, gnd) I tried placing a 15ohm resistor between com and gnd but it seemed to give me the flashing airbag light. Do you remember which pins you put the resistor in?

Thanks

You won't find a bracket; you have to home-make one. That is, just use two aluminium right angle pieces from hardware store, bend it to shape by hand, then slap on some fibre mesh and resin (from a DIY car body repair kit from any car store)

Hey thanks for the message! My Z does have the stock DRLs. What kind of bracket did you use? My problem is that since they do not fit, I dont know of a bracket that I could use to connect lights behind the bumper. If I could find a bracket or something, then I would be ale to use my stock DRLs behind the bumper

Hey! Sorry to bother but I was wondering if you could give me some info regarding your amuse drl? I am going to install the bumper soon and I would very much like to keep my Drls or a variant of it!

Thanks in advance 😊