Staples

RAHHHHHHHHHH, there can only be one Staples center

Question, after parts and labor and the custom tune how much did it all run you. I am considering getting the same kit for my g and just wanted to have a better Idea of what the build would end up costing, thanks.

Thanks a lot for the great & detailed reviewed sir!

Nice mods on the G

ya frank at hills garage fixed it he replaced the bearings in the pulley driveshaft he did not call stillen he just ordered the bearing and swapped them he said its a easy fix

Projects turn to disgust mainly for 3 reasons: 1. Shops are notoriously bad estimating how long something will take. That 2 month project will take 6 months. 2. Owners keep changing their mind...

It certainly beats extreme camber, huge tail spoilers, and the neon-from-Hell look, but there is no way I'm gonna butcher the wiring on a modern car. I've rewired more than one classic car...

your criteria sounds similar to what I was going for with my build, heres my setup: wiseco 10:1 96mm, coated K1 Rods w/ARP 2000 bolts (Carrillo actually owns K1) oem rod/main bearings, calico...

Yea, the AFRs are in the low 11s to redline. If you look at my dyno charts, there's no oddities. Curve is smooth. One of my friends test drove it yesterday since it was nice can "cold" out (no...

As useful as this VVEL is in our engines it has been one hell of a bottle neck.

No I talked to Tony @ FI he said eventually the packing will come out so you should just buy test pipes,I'm sure he is right b/c he was willing to sell me the cheaper test pipes instead of the more...

I am fairly positive that is not knocking. Sounds like valve train noise. Knocking typically happens under load and is less of a tick-tick-tick sort of noise. That sounds too rhythmic to be knocking.

Last weekend I installed TopSpeed's Ti Look Catback Exhaust System on my 2012. I ran into the usual snag with the fitment of the x-pipe to the stock cats, but I was able to overcome that without a...

Sure... I'll make a new thread for that by this weekend.

I don't get this mith that a dual 2.5" exhaust sytem is too small for 650whp+. Cross sectional area of: 3.0" single exhaust is 7.0" squared (supra guys makig up to 700whp single turbo) 3.5"...

Looks like a full day of driving..so if you were to drive up here and have me do the install, there would be no need to make any changes. I would be able to customise the downpipe to work with the...

Well, I think it's safe to say that the most complex jig I have ever built is complete: http://i137.photobucket.com/albums/q204/1997KLDE/370z%20Turbo%20build/IMG_7590.jpg ...