simul8r

Hey Brayan,

I'll be off work all of Xmas week, so I plan on making an audio/video clip and posting it.

Hello simul8r,

I saw your thread about the Nismo R-Tune exhaust and your experiences regarding it. I was windering if you could provide an audio clip to post to the forum or send directly to me.

Best Regards,
Brayan

There was one good thing to come out of it. At the time had a client who was being Charged with armed robbery. It was a court-appointed case so of course he did not trust me. But when I went to...

Yes to my knowledge there is no micron data or I do not know of anyone that has tested the air filters Z1 uses on their Z1 Motorsports full length CAI. I do know from previous Z enthusiasts that have...

I’ve done a quite a bit of research on intakes through the forums. Of all the CAI intake options( Gen 3’s,AAM,Takeda,Admin,etc.) I think Z1 offers the best combination of long tube design, fitment,...

Location isn't much of an issue as long as I can ship you hardware. When I have free cycles I don't mind providing assistance especially to the men and women that serve our country, thank you!

Forget it. The stock intake is better than an intake that pulls air from the engine compartment. Those short rams will show gains on a dyno with a huge fan on them, but they'll heat soak badly in...

Awesome!!!:icon18: I'll more than likely go with Z1 C.A.I . Anybody out there with the 15+ year nismo have any trouble with fitment with Z1 C.A.I. or still G3?

I bought my 2014 Nismo brand new in August of 2014. It had 3 miles on it when I test drove it and had 7 on it when I bought it. Pearl white, the two tone grey, the stock widebody rear end, and oh the...

I had to get both FUCA and rear camber arms and toe bolts when I went to use Swift springs. Every car is different. And this has been discussed to death in the forums.

There are many threads covering this. You probably won’t need front camber arms. You will Almost certainly need rear camber arms, and would benefit from toe bolts. Just get SPL rear camber arms and...

I do know that the Z1 post MAF tubes and drop in K&N air filters will get you about 80% of the gain on the dyno you would see from installing a full length cold air intake kit. The best 100% gains on...

Just chiming in since there aren't many posts on it, but the new AEM intake (21-821DS) is better designed than the K&N. K&N owns AEM. I have the AEM. It sounds amazing, night and day difference. ...

i just want to "tint" my high beam light, damn it's bright!

I don't know what's going on here but an H pipe is more then just a brace. Anyway. Any well designed exhaust will flow good enough to not make a practical difference. A good Y pipe (Tomei); X pipe...

Lol... Well...I use it for stuck rotor removal. Remove the bolt, remove the spacer and then install bolt and use the bolt to advance stuck rotor off the rusty hub. Prevents the hammer action on...

To keep you from accidentally putting a rear OEM wheel on the front. You can remove it safely.