RN SHARK

Greeting's from Clifford and my Doberman Pincher "Princess Diane of Sunnyvale California" forum brother -Clifford

No new pics to the album yet. I did added 20mm spacers all around, an Ark Grip exhaust, and black leather seats from a touring. Really haven't had much free time to work on the car since i got it. It's looking pretty stock right now, hopefully by Summer time i'll get around to install the lip kit and lowering springs. I think by the time I'm done my our Z will be identical twins minus some small details

So you said you won't be able to make it to Auto Club Speedway on Sunday, but are you around tomorrow? I'll be at Specialty Z at 0900 for a tune and after that just kickin it before I check in to a hotel near the speedway.

I hit those cement blocks too often so this lip is a no go. Thanks!

Very nice, I wonder if one cn still get one of those somewhere. Even not signed

Thanks!!

Sorry for the delayed response, thanks for the compliment, I am about 45mins south of SD.

Get some new 3M automotive double sided tape as well. It's a pain to remove the rocker panels because the clips can break. If you have a prying tool it should help minimize the muscle work.

I didn't really follow the instructions either with the INGS +1 kit. The sticky tape and screws supplied didn't seem like it was enough, so I added screws, nuts, and washers. You will need to remove the rocker panels for the installation. Do a test fit and use masking tape to hold the parts together while screwing the parts together. The same for the front lip. I added silicone, which I later regret. It was a mess, and it wasn't really necessary.

Missed a great run last week,,