NismOrly22

Hey man, how’s your Z doing? Anyways, I pretty much have the same setup as you it seems. 2016 Nismo with G3 CAI and Motordyne CBE. I was wondering if you got the MD LTH and if you dyno’ed your Z yet? I hope to make mid 330whp at the very least, 340whp would be wonderful and just wanted to see where you’re at if you did install those LTH?

I swapped my gears for 4.08 when I changed my LSD and have no regrets . Car launches way better and goes through gears like lightning . In for 4 years with zero problems to date .

Big thing to keep in mind with gears, especially 4.08's is your gearing for and against you. At speeds over 90mph, you'd be in the same gears for a shorter amount of time. There would be 10, 14, and...

You'll make very little additional power, the labor bill will be high, and Megan racing is eBay garbage.

Here's a pic of my Z with Swifts finally installed with SPL camber arms. No spacers or alignment yet. I always thought the pic of the Swifts on the dark cherry vert earlier in this thread was...

There is a limit to how much drop the stocks will take, and the more aggressive the drop? The higher chances of premature wear or blowout.

Hey Folks, I've been putting this list together as much as possible. WE have a lot of NEW and existing members who ask about lowering springs, And so I hope this will help since this will be...

I have the ark GTS on my Nismo with OEM Nismo shocks and I love mine, I believe they were engineered to work with factory shocks as well. A bit more of an aggressive drop than the swifts Sent...

Resonated will mean less drone in car, I converted from non-res hfc to lth with res, the drone went down with them and the car isn't very noisy at lower speeds, compared to the hfc

Yeah, it’s almost impossible to get beyond ~330-340rwhp NA on the VQ. If you spend tremendous amounts of money and run exotic fuels, you might pick up another 10-15hp, but that hardly seems worth it....

Ok, trying to think what would be a good weekend for my next attempt.. I'm going to skip December since it would kind of be short notice for any day at this point in the month. Let's attempt another...

I'm no dyno expert. It could be altitude corrected, I wouldn't know. If it is, I'm about 20 hp shy of what I would expect based on my build. Either way, the motor "feels" strong and is pulling...

Review and commentary (longish post) - A few weeks ago, I picked up a used pair of Long Tube Headers from a guy going TT. They were in good shape, but had obviously been used for a little while. I...

Outside of forced induction, the cost of 99% of performance parts for our cars don't justify the gains. $500+ intakes, $1200+ exhausts, etc. Lets not kid ourselves :icon17:

Long tube headers are absolutely not a waste of time, as shown by many dyno charts in this forum. They're just not a great bang for the buck item when you figure in the high labor cost. You're...

Just bite the bullet and get Motordyne; It is the best.