MSC43

Hey, I understand. Thanks for replying even now. I did....I just had never really worked at all with panels/clips/grommets.....didn't know what was in there....but after....VERY frustrating encounter with a local dealership (long story), I just ordered the panel from Z1 and when it came, I just decided to give it a go. Since I rent, and moved to a different city a few years back, I have no garage, most of my tools are gone or in a box somewhere....so with defective pliars, tweezers, keys, and anything else I found offhand, I went out in the freezing cold and just laid into it haha. At one point a neighbor friend came by....watched and opined that he'd help but he just breaks stuff like this....LOL! So yes.... a big ugly, and a few scratches around the grommet, but got it all out one way or another. After seeing it out, I'm sure if i just had the right pliar / pry it would pop out like nothing.

HI, I saw your post about trying to remove a broken clip in the B pillar. Apparently the people who replaced the windshield on the car I just bought made a mess of the panels, and my B Pillar just flew off! I have two clips broken off and stuck in the grommets. Wondering how you solved the issue!

I got it fixed. The cam shaft position sensors replaced corrected one of the problems.... But apparently the battery had low voltage even though I just bought it in 2018.....I had to pay a small fee...

I got it fixed. The cam shaft position sensors replaced corrected one of the problems.... But apparently the battery had low voltage even though I just bought it in 2018.....I had to pay a small fee...

Cleaned the the throttle bodies and MAF's and it's good now. ��....Thanks everyone for the advice.

I got it fixed. The cam shaft position sensors replaced corrected one of the problems.... But apparently the battery had low voltage even though I just bought it in 2018.....I had to pay a small fee...

Nope. Duct Tape. 😅.....For some reason that top piece is built into the finisher and not like the bottom two.

Yes. Long story short I had to replace the Finishers from a bad windshield replacement....they broke the finishers trying to remove them...I messed up the grommets trying to remove the broken piece...

Yep....and two of those cost close to what a windshield costs ...😜

No. But I believe that was the ticking noise I was hearing when first starting the car. It went away after a few minutes. The car was low on oil which is 100% my fault for not checking it...

Thanks......I actually have some of that. It didn't remove it before but I am going to try again and let it soak longer and try more elbow grease. Maybe doing that over and over will remove it a...

Mine just went out. Had a scare a month ago and it drove fine since. Started acting up tonight. Was able to coast into parking lot and park it. Got ride home and will have to get it towed to...