hustleman222

I came across a thread with a guy looking for a 3.9 diff. You mentioned that you might be interested in selling yours. I know its from a couple of years ago, but you still have it and want to sell it let me know. Thanks

They were obviously free. :-)

Headed to the engine machine shop today and discuss my ideas on closing the deck on my block. Hopefully they give me good news and agree to work with me on this project. I haven't seen it done...

Yes sir! This is the exact same pulley setup as what I always have sold. 2.8 serp, 3.2 JS and 3.2 SC side. The Cannon intake is breathing nicely. No doubt we will see 600whp with E85 on...

I was pushing coolant at 625 :shakes head:

Theres been a lot of talk about those lately. I think theres a few guys with builds in the works with them. Hopefully it works out in the long term. 1000hp is hilariously easy for a VQ to make, if...

15 nismo, HKS Hipermax SP coils, Z1 Diff Bushings, Subframe bushings, Wavetrac. Rays 19" 57CRs, 285f ,305 R888R. Boosted Performance single with 6870. S1SE fuel system, 1300 ID Injectors, 340 in...

Noop, the block was sleeved. I forgot the name of the sleeves though. He also has a Bryant racing crank. It is a 4.0 liter. They were not Darton MID sleeves I don't think. It started with an L, I...

I'm sure this will be kept top secret. If someone comes out later and be like we O.Ring the heads and blocked to create a better seal I will:inoutroflpuke:

Man I just watched Adam LZ blow another motor.. That's not what got me. He did a 1.58 60ft on 18" radials. Prior to that he hit 11.7 at 126 rolling out of the box. I'm off the fence. Earlier I...

To shed some light on this. Yes and no. It will be very close but we may not have left enough room for a bash bar so it might move over just a tad. However, we have a metal intake that goes from 3.5"...

Hold that thought, it may take that long to get enough folks for the 5 buy minimum.

Sweet Is that the finished intake ? Sent from my SM-G960F using Tapatalk

So close!! Car wouldn't fit on the Dyno. This rig is slammed and with the widebody kit it was scrapping on the ramps. Also, the shop said the straps would be held tight against the cans on the Berk...

Dyno day... Thursday at 2:00! We will have 93 octane results.

Take the Z out for the first time in 45 days, figure I'd drive sedately around the blocks near home and warm her up. Get half a block before a cop starts tailing me. Follows me through two turns and...

Here are some good finished pictures of my custom built A-Pillar gaugge pod. The only "off the shelf" parts used were a Nissan A-Pillar and Nissan silver gauge trim ring. For those interested, I...