![]() Gibby1113
Enthusiast Member |
Last Activity: 09-07-2018 12:27 AM
- User Lists
Visitor Messages
Showing Visitor Messages 1 to 9 of 9
-
01-24-2013 06:41 AM - permalinkredline727Not necessarily I had mine done at shop with my first one. I had SS rolled tips before I had the Ti tips. And they put the passenger tip on to far and made the tips appear to be uneven. Just enough that it was noticeable to me. And at first I let it go. But after a while it drove me nuts bc I knew it was most noticeable to people driving behind me and that doesn't look good on such a nice car. So one day untried to pull the tips out to the length Invidia designed them and that side I could not get off for the life of me. I got so frustrated I just ordered another rear section and beat that one with a hammer hahaha. Then I put on that rear section my self and made sure the tips were on perfect. I actually prefer them stick out the way Invidia made it. But that's just me I guess.
-
01-22-2013 07:31 PM - permalinkredline727The tips come uninstalled you put them and can push them in further if you want. It's not the easiest task bc they are meant to stick out past the bumper but it can be done. Just be careful bc if you push to far its near impossible to pull them off again. Also if you push to far in on the passenger side bc of the bend in the tail pipe it will make the tips to appear to be uneven.
-
01-22-2013 04:59 AM - permalinkredline727No, it is just a more restrictive HFC. The higher the cell count the more filtering material it has. But 300 cell is still way less restrictive then stock. Hence the reason HIGH FLOW cat.
-
01-21-2013 05:34 PM - permalinkredline727Not raspy at all IMO, you do hear the hiss sound on decel which is typical on any HFC or TP but that's it. They are 200 cel non resonated. As far as the throttle response I can't really say bc I went from test pipes to HFC so to me the TP felt better. But I'm sure going from stock exhaust to HFC and CBE it will feel great.
-
01-20-2013 08:36 PM - permalinkredline727Yeah that exhaust is really nice but between the cost, wait time, and how some people say they scraped it before I went with the Invidia. The quality has been great from all 3 of the products I had from them. Their customer service was great too. There was a leak from the flex sections in the x-pipe and they replaced both pieces for me under warranty no problem. They even recently redesigned that section doing away with the flex pipes and they made sure to tell me to wait for the new design so I didn't have to worry about it happening again.
-
Sweet. I am looking into the F.I TDX CBE and was on their website. It says that they modified their exhaust to rest a little higher than their earlier models due to the fact that some people had been scrapping theirs. Would you happen to know anything about that?
-
01-20-2013 05:44 AM - permalinkredline727From what I have read with a good tuner you may sacrifice some top end whp but will gain some very usable mid range whp. Most seem to say that I read that have it sacrificing a few hp up top (we are talking like beyond 7k in the rpm) is well worth gaining the mid range hp. It is more useable hp especially for these guys that track. Seems like a nice mod.
-
01-19-2013 08:42 PM - permalinkredline727I'm sure Osiris gives you the option. But I couldn't begin to tell you how. I paid for a custom Uprev tune at the shop I go to, so the tuner took care of everything. As far as what you will make its tough to say I made 335whp and 265tq on a Dyno Dynamics Dyno. With the K&N's, Invidia Gemini CBE, Invidia Test Pipes, and Uprev. I haven't been back to the Dyno since I had the HFC's put on. But I'm sure it's a little less. Results are different from dyno to dyno and mod to mod. Important thing is that you make more power and have a the best power curve your tuner can get you. I'm sure the Osiris is great but I would find a shop with a great tuner and just have someone do it on the Dyno. Bc I believe with Osiris you data log your car then send in your data and they send you a map to install. To me it just seemed easier to go to a shop.
-
01-19-2013 06:38 AM - permalinkredline727@gibby1113 when my car was tuned I actually had Invidia test pipes installed the same day. My check engine light did come on. Then when they tuned my car they disabled the rear O2 sensors so the light would go off. Shortly after I had to switch to HFC's to pass state inspection since the rear O2's were already disabled I can't say if they would through the light or not. But I do know that the Invidia HFC's are only 200 cell which is the least restrictive I could find so I'm pretty sure they will throw a check engine light. But if your definitely gonna get an uprev tune the tuner can disable the rear O2 sensors and light goes out anyway
About Me
- About Gibby1113
- Location
- On open empty highways
- Drives
- 40th anniversary
-
Signature
- 40th anniversary #450/1000 | Takeda Attack CAI | Ark DTS exhaust | to be continued...
Friends
Showing Friends 1 to 4 of 4
-
- Joe711
- Base Member
-
- redline727
- Base Member
-
- SS_Firehawk
- Premium Member
-
- tiger123
- Enthusiast Member
Likes Received
35 Likes
-
NoirG liked post by Gibby1113 On thread : FI long tube headersYou would have to remove the hfc completely. Long tube headers connect from the engine straight into your exhaust. No restrictions = more air flow = more power = sweet exhaust note.Liked On: 11-05-2014, 01:35 AM
Posted On: 11-05-2014, 12:23 AMrichiivu liked post by Gibby1113 On thread : Ark dt-s muffler section onlyIf anyone buys this and doesn't want the tips send me a pm I'll be glad to take them off your hands. :tup:Liked On: 04-11-2014, 01:34 PM
Posted On: 04-11-2014, 11:29 AMSterlingDrive liked post by Gibby1113 On thread : I hit two raccoons this week..Remove the angry bird. Cut off the raccoons tails and hang them there instead so other raccoons know what you're capable of....Liked On: 03-16-2014, 06:54 AM
Posted On: 03-16-2014, 01:05 AMka24king liked post by Gibby1113 On thread : Looking for Input on Silicone PCV Breather HosesIf you upgrade to aftermarket intake the stock PVC hoses will crack eventually. I know because I am speaking from experience. Mine crack, I order the Z1 hoses, installed them, haven't had any issues...Liked On: 03-10-2014, 12:56 PM
Posted On: 03-10-2014, 12:40 PMO&G liked post by Gibby1113 On thread : Built Engine CompleteHaha I mean no disrespect, I just lost it when I heard that engine rev. I had to have it haha but seriously though, if you could post up prices I'm MORE than sure some people would be willing to pay...Liked On: 02-22-2014, 12:36 AM
Posted On: 02-21-2014, 11:20 PMGaleForce liked post by Gibby1113 On thread : Built Engine CompleteHaha I mean no disrespect, I just lost it when I heard that engine rev. I had to have it haha but seriously though, if you could post up prices I'm MORE than sure some people would be willing to pay...Liked On: 02-21-2014, 11:24 PM
Posted On: 02-21-2014, 11:20 PMRiptide67 liked post by Gibby1113 On thread : stillen sways...need end link opinions!Was I not clear on my first post :icon18:Liked On: 02-07-2014, 01:44 PM
Posted On: 02-07-2014, 12:15 PMkenchan liked post by Gibby1113 On thread : stillen sways...need end link opinions!Was I not clear on my first post :icon18:Liked On: 02-07-2014, 01:23 PM
Posted On: 02-07-2014, 12:15 PMOMGWTFBBQ liked post by Gibby1113 On thread : stillen sways...need end link opinions!Buy SPL. Whitelines end links break. That is all.....Liked On: 02-07-2014, 01:27 AM
Posted On: 02-06-2014, 11:11 PMRiptide67 liked post by Gibby1113 On thread : stillen sways...need end link opinions!Buy SPL. Whitelines end links break. That is all.....Liked On: 02-06-2014, 11:15 PM
Posted On: 02-06-2014, 11:11 PMRumbleFish liked post by Gibby1113 On thread : Fast Intentions Exhaust w/ 18" ResonatorsThis is gonna be done by the end of the day. Crazy good dealLiked On: 02-03-2014, 05:55 PM
Posted On: 02-03-2014, 05:24 PMZCRUZIN liked post by Gibby1113 On thread : Fast Intentions Exhaust w/ 18" ResonatorsThis is gonna be done by the end of the day. Crazy good dealLiked On: 02-03-2014, 05:33 PM
Posted On: 02-03-2014, 05:24 PMka24king liked post by Gibby1113 On thread : Motordyne intake manifold M370Yea I read that they don't have them anymore but oh well :mad: thanks though :tup:Liked On: 01-10-2014, 09:52 PM
Posted On: 01-10-2014, 09:23 PMDEpointfive0 liked post by Gibby1113 On thread : Motordyne intake manifold M370Yea I read that they don't have them anymore but oh well :mad: thanks though :tup:Liked On: 01-10-2014, 09:23 PM
Posted On: 01-10-2014, 09:23 PMSouthArk370Z liked post by Gibby1113 On thread : DIY: Replace dreaded steering-lock on 2009s and early 2010s.Alright guys so I gave a call to the nissan dealership that is 30 mins away from my house, brought up the recall, they asked for my VIN, told me my car was on recall, they had model D in stock, told...Liked On: 01-09-2014, 12:37 AM
Posted On: 01-09-2014, 12:35 AM
All times are GMT -5. The time now is 08:02 PM.