Nissan 370Z Forum  

Go Back   Nissan 370Z Forum > All Albums > Equinox's Profile > Albums


Racing Seats and Airbag Fix
Took the stock air bag weight sensor out of the passenger seat and installed it into the bride gias seat to allow the passenger air bag to arm when someone is in it. Also, installed resistors in the SRS airbag harness' to make all airbag lights go away.
Bottom of passenger seat. Remove the bolt that is flat into the lower pad, not the one sitting at an angle on the bracket to the side. The bolt is...
Bottom of passenger seat. Remove the four bolts on the bottom of the seat holding the lower pad in. Just these four bolts actually hold the lower pad...
The bottom of the passenger seat. (Note, passenger weight sensor, and SRS airbag system have already been removed, so there are no electrical...
Here the resistor is being soldered on. The resistor needed is a 4.7 OHM, 1/2 watt resistor. Radio shack didn't have it so I ordered it online. You...
Here the resistor has been soldered on and heatshrinked. The resistor needed is a 4.7 OHM, 1/2 watt resistor. Radio shack didn't have it so I ordered...
HEre you see the stock connector harness stripped and ready to accept a resistor
Supplies you need to clear the airbag dash light after you remove the stock seats and replace them with racing seats (SRS airbag is in the stock...
Passenger Air bag now armed in a Bride Racing Seat equipped car.
Passenger Air bag weight sensor put in the Bride Gias racing seat. The pads are velcro and just pull up so you can take them out and machine wash...
Bride Gias seat with passenger air bag weight sensor under the seat pad. The pads just pull up with velcro, so you can machine wash them if you want.
This is the a stock Nismo seat with the fabric covering removed, and unbolted from the seat frame. The black cover on the seat foam is the passenger...

All times are GMT -5. The time now is 05:39 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2