Nissan 370Z Forum  

370Z Forums HOME My Picture Album Nissan 370Z Pictures Premium Membership Become a Forum Sponsor
Go Back   Nissan 370Z Forum > All Albums > bpd138's Profile > Albums
Reload this Page Kenwood DNX8120 Installation
Register All Albums FAQDonate Members List Calendar Today's Posts


 
Page 1 of 2 1 2
Kenwood DNX8120 Installation
Pics of DNX8120 Installation
Img 0777 1 Rear view cam Video wire connection at head unit. Once you wrap your head around all the wires there really is plenty of room to stow...
Img 0776 1 Rear view cam. I drilled a .2" dia hole through the plastic bumper facia for the wire behind the cam. This hole lined up with the...
Img 0775 1 Wire from rear view camera. Theres a rubber grommet on the passenger side rear wall. It comes out just above and to the right of the...
Img 0774 1 Ground wire for rear view cam
Img 0773 1 Wire routing for rear view cam. After I tested everything I cut the wires shorter and tidied them up.
Img 0772 1 Amp in place. you need the space clear to the left of the amp otherwise the foam block won't sit flush.
Img 0771 1 Amp in place
Img 0770 1 Speaker, Ground and power connections. The black tape on the speaker wire was so I knew which was the right and which was the left.
Img 0769 1 Pre-outs from Kenwood DNX8120. I ran them straight down through the center console. Take the two screws out of the back of the center...
Img 0768 1 Infinity Reference 475a Amp. I mounted the amp on a peice of pressboard. This allows you to drill holes in the pressboard so that it...
Img 0767 1 Bluetooth mic mounted on drivers door pillar. It is crystal clear!
Img 0766 1 Power wire for amp routed through the firewall on the drivers side. Theres a small rubber knockout that you can access just behind the...
038 Kenwood Reverse Wire Connection to Factory Back Up Lights (Orange Wire)
037 Kenwood Reverse Wire Connection to Factory Back Up Lights (Orange Wire). I continued to run the back up wire to the rear of the car for power...
036 Kenwood Reverse Wire Connection to Factory Back Up Lights (Orange Wire)
035 Path that I ran the reverse wire along
034 Path that I ran the reverse wire along. The red wire is the amp turn on wire. The reverse wire runs from the center console to the drivers...
033 Door speaker connections. I used the fatory wiring and cut the factory plugs off. I then soldered new conectors onto the speaker wires. it...
032 Removeable foam block behind cross brace. it is quite flexible and you can get it out without removing the sides but it is a pain and it will...
041 It works!
040 It works!
039 It works!
031 Theres lots of wires to shove into the dash!
030 Theres a lot of wires to stuff back in when you put the head unit back in. I put some of them in the gap under the head unit and stuffed others...
029 GPS Antenna
028 I ran the rear speaker wires, reverse wire and amp power turn on wire through the center console. Make sure you run them under the plastic...
027 Rear Speaker wires coming into the dash behind head unit from center console
026 Tip of coat hanger used to pull wires through center console
025 Tip of coat hanger used to pull wires through center console
024 Kenwood to Factory wire harness. The colors matched! At least the important ones did. The speaker wires are different colors but its not hard...
 
Page 1 of 2 1 2

All times are GMT -5. The time now is 09:04 AM.

Contact Us - Home Page - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2