Nissan 370Z Forum - bpd138's Album: Kenwood DNX8120 Installation

Nissan 370Z Forum

370Z Forums HOME

My Picture Album

Nissan 370Z Pictures

Premium Membership

Become a Forum Sponsor

		Nissan 370Z Forum > All Albums > bpd138's Profile > Albums
Kenwood DNX8120 Installation

Page 2 of 2

2

Kenwood DNX8120 Installation

Pics of DNX8120 Installation

023
Kenwood to Factory wire harness. The colors matched! Note the blue antenna wire from Kenwood hooks to the blue power wire on antenna harness...

022
Factory plug. Look at it from the back to compare it to the picture in the service manual. Note, big yellow wire on left is pin 19.

021
Factory plug. Look at it from the back to compare it to the picture in the service manual. Note big yellow wire on left is pin 19.

020
Looks like plenty of room for extra wires. Little did we know!

019
Removing the factory head unit. Reach in back and unplug the radio and antenna plugs.

018
Removing the four screws that hold the factory head unit in place

017
Removing the factory head unit

016
Removing the four screws that hold the factory head unit bracket in place

015
Press the small tab to remove the hazard light swithc plug

014
Remove the four screws that hold the dash console in place

013
Air bag sensor plug

012
After removing the two screws at the base. Pull out at the bottom and the storage thingy pops right off.

011
Start pulling at the base and work your way up the sides

010
Remove the two screws at the base

09
Center console sides

08
Afte rthe two screws are removed it just pull straight off

07
Remove the two screws holding the center console sides in place

05
Lift at the back and then pull gently rearward

04
Insert a plastic trim tool and lift up. it comes off really easy.

03
Remove the hazard light plug. Theres a small tab that needs to be pushed in to remove it.

02
Lift at the back and then pull gently rearward

01
Insert a plastic trim tool and lift up. it comes off really easy.

Page 2 of 2

2

All times are GMT -5. The time now is 11:49 AM.