jwick Build Thread - First BP - G37T in existence

[Boosted Performance]

Originally Posted by jwick

Cons:
- Getting the 4th turbo flange bolt installed is pretty tricky and takes a little time. Nothing as frustrating as the old coupler location, but still takes a bit of effort.
- The turbo charge pipe is now the lowest point of my car (you can see if in the photos). I don't think I lost any effective high-center distance because it is still pretty close to the front tires but it is the lowest point. It is NOT tucked up above the sub-frame.

I assume that you are talking about the turbo flange bolt, at the top, closest to the compressor cover. It helps if the oil reservoir is off the turbo, but yes, it is the toughest bolt to get at on the manifold..

On the IC pipes, as a result of your reviews, I will update the pipe and send you that section at no charge….

The pipe that goes under the transmission and couples to the turbo will be made from two pieces and coupled with a silicone coupler (vs single pipe). The other change is that the section going under the transmission, and in to the compressor outlet will be 2.25” vs 2.5”. This is the same size as the compressor outlet inside diameter, so it is not a reduction.

This will allow for better clearance, and give the installer flexibility in this section.

Here is the two pieces side by side:



On the left you can see how the (new revised) lower pipe slides in to the upper pipe. This is where the flexibility will happen, making the install even easier. If, for some reason, somehow this pipe is damaged on the road, over a bump…whatever, I will send a replacement at no charge, and cover the shipping.

[jwick]

Originally Posted by Boosted Performance

I assume that you are talking about the turbo flange bolt, at the top, closest to the compressor cover. It helps if the oil reservoir is off the turbo, but yes, it is the toughest bolt to get at on the manifold..



On the IC pipes, as a result of your reviews, I will update the pipe and send you that section at no charge….



The pipe that goes under the transmission and couples to the turbo will be made from two pieces and coupled with a silicone coupler (vs single pipe). The other change is that the section going under the transmission, and in to the compressor outlet will be 2.25” vs 2.5”. This is the same size as the compressor outlet inside diameter, so it is not a reduction.



This will allow for better clearance, and give the installer flexibility in this section.



Here is the two pieces side by side:







On the left you can see how the (new revised) lower pipe slides in to the upper pipe. This is where the flexibility will happen, making the install even easier. If, for some reason, somehow this pipe is damaged on the road, over a bump…whatever, I will send a replacement at no charge, and cover the shipping.

Sasha you da man! You are always improving the kit and taking care of us. Many should take a lesson from the way you treat customers.

The bolt you described is the exact bolt I was referring to and I did in fact pull the oil reservoir to get at it. You are awesome to send me a new set of pipes as it is definitely not required of you but that's just the business man you are.