|
i wish i could have taken a pic of me drilling it... but i was a little in a hurry since i had to go work... this is what i
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-29-2013, 03:32 PM
|
#11 (permalink) |
|
A True Z Fanatic
 
Join Date: May 2009
Location: Dededo, Guam
Posts: 6,642
Drives: solid red 370z 6mt
Rep Power: 405   |
i wish i could have taken a pic of me drilling it... but i was a little in a hurry since i had to go work... this is what i meant...
   center the bar...make sure the mounting tubes are mounting FLAT and not tilted... clamp those bad boys down.... and take a drill to them like boss... after that... replace the bolts with grade 8 bolts... dont drill the holes TOO big... just enough so the grade 8 bolts will go through... lastly the sandwhich plates that go on top of the bar to mount... you will have to flip them.... since there is no holes where there should be holes so that you can mount them correctly and the welded nuts on the mounts wont be in the way anymore...
__________________
 ***TOP SECRET/POWERHOUSE AMUSE/ARC/DAYTONA RACING/VARIS/MINES/GANADOR/J-LINE/WORK EMOTION CR KAI/GT SPEC/CARBON SIGNAL/ZOOM ENGINEERING/ CARBON FIBER ELEMENT/STILLEN/***
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mike's Journal | Mike | Member's 370Z Gallery | 638 | 08-11-2023 10:06 AM |
| KillerBee370's journal | KillerBee370 | Engine & Drivetrain | 100 | 08-18-2010 01:58 PM |
| SIMOTA1 got rear ended.... f*ck | simota1 | Exterior & Interior | 76 | 10-18-2009 09:13 PM |
| Simota1 FIRST PHOTOSHOOT!!!! check out some of the pics taken by my friend | simota1 | Exterior & Interior | 18 | 07-27-2009 06:55 PM |
| Imag Z journal | imag | Member's 370Z Gallery | 4 | 05-06-2009 02:05 PM |
1371Likes
Threaded Mode
