.c2's 2009 Magnetic Black 370z

.c2

Thanks! Didn't get any good full side profile shots yet lol, but going for a shoot tomorrow so hopefully I'll have some to post up here I was running 25mm rear and 20mm front spacers on my stockies after I dropped it, on 285/35 rears and 255/40 fronts.

So this happened on Wednesday..
[Beware] Lotus Autobody (Richmond, BC)


Front lip fell off due to a bad mounting job by Lotus and also bad judgement on my part for actually trusting them when they said that the lip will hold with their install. Lip fell off on the highway while I was going 120km/h and my car actually pushed it on the ground, and it dragged for a while so the concrete sanded a hole in the bottom of the lip.. The crappy shop said it wasn't fixable because it's carbon fiber. So my car looked like this for a few days


I don't have the $550 that I want to spend on another front lip, so with the help of my friend we fixed the lip with fiberglass resin and sanded it back down.


Few days later, I properly mounted the lip back on. Cost of repairing and mounting materials was less than $30, and it's mounted a LOT more securely than when it was done for $100 at Lotus Autobody... You get what you pay for for shops, but you get what you spend time on for DIYs.

Lotus autobody used 2 self tapping screws in total, about 30 cm of 3m tape which barely even covered the corners, and that was it.
I used 3m tape almost all around (ended up running out of tape or else I would have covered the whole thing lol..), silicone all around the edges, 4 bolts w/ washers and locking nuts, and also a bracket + bolt on the bottom of the lip. Install only took a bit over an hour in total with the help of a friend

Having space to work on my car is a huge help. After silicone and 3m tape


The 2 bolts and locking nuts, the top hole was originally drilled by Lotus Autobody. You can see that they ****** up the inside of my bumper with their shitty drilling skills too. Once the lip fell off I actually realized that Andrew @ Lotus Autobody CRACKED my bumper with their shitty drilling skills. The lip just covers it... Well nothing can be done about that now :/


Since the bottom of my lip is lower than the bottom of my bumper, I bought two L brackets at home depot and made a U bracket so I could mount the lip to the bumper. Just a bit more reinforcement



Anddd all done.. properly mounted and slightly cleaned up my engine bay a little. The 350z in the back is owned by my awesome friend who helped me with the repair and install of my lip



Washed as well, even though it's raining tomorrow. So happy to finally have my lip back on

__________________