Sh0velMan's Track Car Build

wstar · 04-17-2013, 09:06 PM

Quote:

Originally Posted by Sh0velMan

The Stillen install instructions tell you to torque to 33 Ft/Lbs and then make a mark on the pulley and bolt and then turn the bolt again until the marks are 90 degrees off... Which I found to be totally impossible. I used the break (sans the bumper support lmao) to turn it as far as I could and only got it about 2/3rds of the way to 90 degrees.

Wstar, were you able to?

Yeah. I used anti-seize on it as well. If you didn't, that could've made a difference. Either way, I doubt 60 degrees is going to cause you problems.

Sh0velMan · 04-17-2013, 09:09 PM

Quote:

Originally Posted by wstar

Yeah. I used anti-seize on it as well. If you didn't, that could've made a difference. Either way, I doubt 60 degrees is going to cause you problems.

I put anti-seize on the junction between the crank and pulley, but I didn't put any on the threads....

****. I want to try and get it off and put some anti-seize on it now...

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wh1te370z - BMW 328is Track Car Build	wh1te370z	Other Vehicles	25	03-22-2012 10:21 AM
United touge/track drivers Streets of Willow Track Day	K.R.O.P.S.	Southern California Region	0	10-05-2011 07:25 PM
Forged Performance: R35 GT-R Track Day Build	ChadB@Forged	Track / Autocross / Drifting / Dragstrip	2	06-10-2011 09:40 PM
Datsun Roadster 1600...To build or not to build	motoextreme	The Lounge (Off Topic)	66	02-13-2010 12:40 AM