|
1st, and 2nd. Removing the old front bushings. So that I can install the SPL bushings. 3rd. The rear SPL diff bushings installed. I put the SPL bushing in the
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-07-2018, 10:32 PM
|
#11 (permalink) |
|
Ronin Samurai - Assassin
 
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 69
Posts: 35,356
Drives: 2011 Nismo GM 6M
Rep Power: 2684438   |
1st, and 2nd. Removing the old front bushings. So that I can install the SPL bushings.
3rd. The rear SPL diff bushings installed. I put the SPL bushing in the freezer overnight. My stock bushing wasn't leaking. It was FULL of silicone. So when I drilled into the bushing. I got a face full of silicone.  Used a drill and a burr bit to remove the center section of the stock bushing. Then a sawzall to cut the outer shell of the bushing. Then used a muffler tool on my air hammer to remove the outer shell. Then used a flapped wheel on a die grinder to polish the hole in the sub-frame. Smeared grease around the inside of the hole. Installed the frozen SPL bushing into the hole using all thread as a puller. The diff in steady to install at this point.
__________________
 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| O&G's Journal | O&G | Member's 370Z Gallery | 648 | 02-16-2017 03:30 PM |
| birdmanx1's Nismo Journal ... | birdmanx1 | Member's 370Z Gallery | 441 | 10-20-2012 03:47 PM |
| TROOPER's 370Z NISMO Journal | TROOPER | Member's 370Z Gallery | 124 | 07-29-2011 09:17 AM |
| [Equinox] Nismo dyno progression journal | Equinox | Engine & Drivetrain | 3 | 02-17-2011 03:11 PM |
| Z BEST Journal | Z BEST | Member's 370Z Gallery | 26 | 01-09-2011 03:19 PM |
2321Likes
Threaded Mode
