WDRead's Z - Past to Present

CrownR426

You need a rear camber kit before your rear tires get uneven tread wear.
Your sway bars may be making this worse...
That should be at top of your list.
Afterwards an exhaust is definetly needed.
And a tune would also benefit!
Car looks great btw, springs in general take a bit to settle so I don't know if you noticed but I'm sure it dropped a lot more than when you first installed them!
Nice journal, keep it up!

__________________
Love + Hardwork + Passion
RIP SVTRacer

VaGntlmn

Thanks Crown.
Front and Rear camber kits are on the way.
Now if I could just get some sunlight to get some better pics.....

__________________
Bill
2010 370z; Tour/Sport; 6mt; BlackCherry/Grey; 318 rwhp; 265 lbs rwtq.
To view a list of my mods, click here; To view a photo journal of the mods, click here.

VaGntlmn

The list of mods is getting too long for my signature block.
I think I'll just put it in a list here.

• Interior
  • iSimple IPOD Gateway
  • Swapped out Stick shift knob - AGAIN - 9/8/11
• Exterior
  • Tinted: 20/50/35
  • Swapped out the Nissan logo on the hood
  • Side-shine LEDs under the headlights
  • EVO-R Front Lip
  • Paint Sealed - Ziebart Diamond Gloss
• Suspension - Lowered the Z about an inch
  • Swift Springs
  • Stillen Sways
  • SPC Camber Kits, front and rear
  • Installed H&R 20mm DRM spacers on the rear
• Intake - K&N Typhoons
• Exhaust
  • Stillen Headers
  • Berk HFC's
  • Tanabe Y-Pipe
  • Tanabe Medalion CBE
• Dyno Results
  • Dyno Tuned - Hills Garage - 8/20/11
    • RWHP: 318.1
    • RWTQ: 265 ftlbs
  • 3 Dyno Pulls - PTuning - 4/20/11
    • RWHP: 298.1
    • RWTQ: 234.9 ftlbs

__________________
Bill
2010 370z; Tour/Sport; 6mt; BlackCherry/Grey; 318 rwhp; 265 lbs rwtq.
To view a list of my mods, click here; To view a photo journal of the mods, click here.