Nissan 370Z Forum

Nissan 370Z Forum (http://www.the370z.com/)
-   Member's 370Z Gallery (http://www.the370z.com/members-370z-gallery/)
-   -   Terbo's 370 Dyno day/Berk exhaust install! (http://www.the370z.com/members-370z-gallery/23935-terbos-370-dyno-day-berk-exhaust-install.html)

terbo 08-22-2010 06:41 PM

Terbo's 370 Dyno day/Berk exhaust install!
 
After months of anticipation, my Berk cat back exhaust and hi flow cats finally came in the mail a week or so back. This last Friday I scheduled to have everything installed and dyno'd before and after the install at my local tuner shop, Robert's Imports (big shout-out to them!) I woke up bright and early Friday, my dad swung by and we loaded up the new exhaust in it's ginormous box and headed out to the shop. We get there, unload everything and within 10 minutes my car is strapped to their DynoDynamics dyno. We did three runs to establish a nice baseline.
http://www.youtube.com/watch?v=Wi2SpvdKkjc
http://www.youtube.com/watch?v=I0jjygblR-o
http://www.youtube.com/watch?v=CyavznEigzI

Each run overlaid the previous almost exactly, and the average peak power was 258 whp. Next my car was taken off the dyno and put up on the rack in order to get a set of new pipes.

http://i181.photobucket.com/albums/x...Z/IMG_0204.jpg
Getting on the rack.

http://i181.photobucket.com/albums/x...Z/IMG_0205.jpg
Under the beast. Stock exhaust.

http://i181.photobucket.com/albums/x...Z/IMG_0207.jpg
All stock.

While Bill, the shop manager, was working on removing all the stock components, I tore open the new goodies.

http://i181.photobucket.com/albums/x...Z/IMG_0208.jpg
New high-flow cats.

http://i181.photobucket.com/albums/x...Z/IMG_0209.jpg
Berk Cat Back Exhaust all laid out and still wrapped.

http://i181.photobucket.com/albums/x...Z/IMG_0211.jpg
It's Christmas!

http://i181.photobucket.com/albums/x...Z/IMG_0212.jpg
Old and busted.

After a good 1/2 hour of wailing away on the stupid cats, Bill finally got them out. For some reason Nissan's engineers are morons and didn't design this with maintenance in mind so it makes removing the stock cats very very difficult. I.E. rounding off a bolt or two.

http://i181.photobucket.com/albums/x...Z/IMG_0213.jpg
Bill happy the stock cats are finally off.

http://i181.photobucket.com/albums/x...Z/IMG_0214.jpg
New Berk Hi-Flow cats on!

http://i181.photobucket.com/albums/x...Z/IMG_0217.jpg
X Pipe installed.

http://i181.photobucket.com/albums/x...Z/IMG_0218.jpg
Berk CBE installed!

http://i181.photobucket.com/albums/x...Z/IMG_0220.jpg
New hotness!

While it was still in the air, I checked all the stuff I've read of people giving them grief. I measured the gap between the tips and the bumper and checked the hangers. Everything checked out perfectly. The gap between the tips and bumpers was exactly the same, not even a 32nd difference. Beautiful fit and finish!

http://i181.photobucket.com/albums/x...Z/IMG_0222.jpg
Pure sexiness.

Now that the exhaust was installed, it was time to strap it back on the dyno and see what it would do.

http://i181.photobucket.com/albums/x...Z/IMG_0225.jpg

http://i181.photobucket.com/albums/x...Z/IMG_0224.jpg

http://i181.photobucket.com/albums/x...Z/IMG_0223.jpg

http://www.youtube.com/watch?v=MLlJidgObBE

This first run was a bit surprising, only putting down 266whp for a gain of +8whp peak. Bill thought this odd and noticed that the coolant temps were not up to proper operating temps yet, so we let it run on the dyno for a few minutes while it warmed up. Once it was nice and warm, Bill let her rip once more.

http://www.youtube.com/watch?v=rabsI-B8LCk

This run was just as Bill suspected, the power increased to 270whp. The next two runs were done back to back.

http://www.youtube.com/watch?v=UcjsMMPeoVE
http://www.youtube.com/watch?v=bREFkvEbM9s

These two runs produced exactly the same graphs. Peak power went up to 273whp (okay okay, 272.8, but it's close enough we're going to call it 273.) +14whp on a dynodynamics, not bad methinks. In case you were wondering, the DynoDynamics dynos do read lower than Mustang dynos and Dynojets. Typically the Mustang reads 14% higher while the Dynojet will read 18% higher.

http://i181.photobucket.com/albums/x.../DynoGraph.jpg
+14whp!

So that's my dyno day. Bill said that after a few drives that the ECU would relearn my driving and the car may pick up a few more whp even. I have taken video of driving the car with stock exhaust and with the new Berk CBE and cats, I just have yet to get around to uploading it. I'll be sure to update this thread when I do :) As for the sound? It's orgasmic. So very sexy. I can actually feel and hear the car now, unlike when it was stock. When cruising it can be quiet and unsuspecting, but when you lay the hammer down it just roars. I love it!

Boost_lee 08-22-2010 06:52 PM

Thanks for taking the time to do the baseline runs. Great vids, and makes the stock exhaust seem like a joke

Was the ECU reset while the Berk was installed? I'm pretty confident that you will pick up a bit more hp after a few hundred miles of driving.

One_Quick_Z 08-22-2010 07:18 PM

Thanks for the write up!


DAN

Jamaica 08-22-2010 07:27 PM

good job. Enjoy the exhaust.

memorylasts 08-22-2010 07:52 PM

Thank you for the write up and the testing, give it a couple days and it will feel stronger!

terbo 08-22-2010 08:24 PM

Boost Lee, no the ECU was not reset. That's part of the reason why we were only seeing 8 whp immediately after installing the new exhaust.

Thanks everyone! I'll have comparison videos up soon, most likely tomorrow! :D

AK370Z 08-23-2010 03:55 AM

wow.. Very nice numbers. Exhaust looks great too. It was def worth the wait. :tup:

RCZ 08-23-2010 08:10 AM

270 on a DD is great for the mods. Congrats!

terbo 08-23-2010 08:23 AM

Thanks everyone! I freaking love this exhaust. It makes the car so much more sports car like.

terbo 08-23-2010 03:57 PM

In recent news, today I met up with a buddy and ran his modded ISF. He said he put down 327whp on a DynoJet so we figured it would be a fun race. We did some runs, from 40 rolls and 60 rolls. The 40 rolls usually ended with his rear bumper at my front bumper. The 60 rolls had his rear tires at my front bumper at the end. Then we did another and he turned on the bottle and put bus lengths on me :(

BOLIO 671 08-29-2010 06:37 PM

Wow...a V8 with a bottle...Now that's just straight up bullying....Wonder how it would pan out in the 1/4 mile from dead stop...motor vs motor...No bottle

ImportConvert 08-31-2010 02:33 AM

Air/Fuel changes?

ThoriumHotdog 11-14-2010 12:31 AM

Deciding is never easy. FI or Berk?! I love the way this exhaust sounds and I like how it almost looks stock.

3pitbulls 11-14-2010 02:50 AM

ordering parts for my nismo, berk cats and injen intake any idea how much power i should pick up? and what do you guys mean when ask if ecu was reset?how do you reset it? any feedback is appreciated hanks/////http://www.westtexasnissan.com/AP/20...D/10495149.jpg

terbo 11-15-2010 11:31 PM

Quote:

Originally Posted by ImportConvert (Post 701519)
Air/Fuel changes?

Sorry, can't say :(.
Quote:

Originally Posted by ThoriumHotdog (Post 808879)
Deciding is never easy. FI or Berk?! I love the way this exhaust sounds and I like how it almost looks stock.

The stock-look was a big part of it for me. I'm not a fan of the angled exhausts, too ricey for my tastes. Also, the sound of the Berk is amazing. It truly cannot be captured on video perfectly.


All times are GMT -5. The time now is 08:27 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2