Mr. G. Brettin's Slow Motion Leg Hump

gbrettin · 09-12-2022, 09:39 AM

I finally wrapped up the mold. There are a few pin holes in the mold but they can all be filled with filleting wax or plasticine clay. Also, the edges will be of the part will be filled with some filleting wax and draft angles created so the B side of the mold will come off.

Tonight I will prep the part for the B side casting by doing what I said above and cleaning up the part a bit more with some light sanding. The inside of the cubby also needs a bead of wax which will prevent the mold material from leaking into the cubby and for another draft angle.

If I haven't said this already, the mold will only be used for vacuum bagging and not doing compression molds at this point.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Racing in Slow Motion IV	MightyBobo	The Lounge (Off Topic)	4	03-12-2013 08:12 PM
Racing In Slow Motion IV	Robert_K	The Lounge (Off Topic)	1	07-13-2012 11:01 AM
Slow shipping slow response slow everything	thispecialk	Nissan 370Z General Discussions	15	11-01-2010 08:23 PM
Racing in Slow Motion	MightyBobo	The Lounge (Off Topic)	2	12-17-2009 03:27 PM
IIHS Small Car Test: Three Gruesome Slow-Motion Crash Videos	AK370Z	Other Vehicles	13	04-15-2009 09:42 AM

09-12-2022, 09:39 AM	#11 (permalink)
gbrettin A True Z Fanatic Join Date: Oct 2010 Location: Portage, MI Posts: 2,294 Drives: Tricycle Rep Power: 589151	I finally wrapped up the mold. There are a few pin holes in the mold but they can all be filled with filleting wax or plasticine clay. Also, the edges will be of the part will be filled with some filleting wax and draft angles created so the B side of the mold will come off. Tonight I will prep the part for the B side casting by doing what I said above and cleaning up the part a bit more with some light sanding. The inside of the cubby also needs a bead of wax which will prevent the mold material from leaking into the cubby and for another draft angle. If I haven't said this already, the mold will only be used for vacuum bagging and not doing compression molds at this point.