Mr. G. Brettin's Slow Motion Leg Hump

gbrettin · 08-18-2021, 10:14 AM

Went to Lane Automotive, It's like Summit but a 40min drive, to get more fittings. I also picked up an Optima Red Top battery and an ICT billet hold down. Unfortunately They forgot to pick my battery hold down and I left with out double checking them loading the car. bummer.

I had to run through all the fittings like 10 times minimum in my head before heading out to Lane Automotive but I nailed it all down. I even found a trick -10orb to -8orb coupler that I can use to plumb in the dual -6 to -8.

A bit of massaging was needed for the CJM fuel hat to make the -8 return work. If you check out JCHammond's build, he has crimped lines that flow like -8. Or something like that. It's far more impressive than my hood rat grinding solution. However, I needed to make what I have work.

Lastly, I added some bad *** high flow mesh screens to the fuel pumps.

I suspect that the tank can go back in tonight now that all the fittings are here.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Racing in Slow Motion IV	MightyBobo	The Lounge (Off Topic)	4	03-12-2013 08:12 PM
Racing In Slow Motion IV	Robert_K	The Lounge (Off Topic)	1	07-13-2012 11:01 AM
Slow shipping slow response slow everything	thispecialk	Nissan 370Z General Discussions	15	11-01-2010 08:23 PM
Racing in Slow Motion	MightyBobo	The Lounge (Off Topic)	2	12-17-2009 03:27 PM
IIHS Small Car Test: Three Gruesome Slow-Motion Crash Videos	AK370Z	Other Vehicles	13	04-15-2009 09:42 AM

08-18-2021, 10:14 AM	#11 (permalink)
gbrettin A True Z Fanatic Join Date: Oct 2010 Location: Portage, MI Posts: 2,294 Drives: Tricycle Rep Power: 589151	Went to Lane Automotive, It's like Summit but a 40min drive, to get more fittings. I also picked up an Optima Red Top battery and an ICT billet hold down. Unfortunately They forgot to pick my battery hold down and I left with out double checking them loading the car. bummer. I had to run through all the fittings like 10 times minimum in my head before heading out to Lane Automotive but I nailed it all down. I even found a trick -10orb to -8orb coupler that I can use to plumb in the dual -6 to -8. A bit of massaging was needed for the CJM fuel hat to make the -8 return work. If you check out JCHammond's build, he has crimped lines that flow like -8. Or something like that. It's far more impressive than my hood rat grinding solution. However, I needed to make what I have work. Lastly, I added some bad *** high flow mesh screens to the fuel pumps. I suspect that the tank can go back in tonight now that all the fittings are here.