so i usually buy the 5qt jug at walmart to do the oil change, and a one qt bottle for topping off.. when i open the bottle i sharpie a
|
|
LinkBack | Thread Tools | Display Modes |
09-22-2014, 11:26 AM | #316 (permalink) |
A True Z Fanatic
Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141521 |
so i usually buy the 5qt jug at walmart to do the oil change, and a one qt bottle for topping off..
when i open the bottle i sharpie a date on it. usually dispose the remaining oil in the bottle if over a year old. |
09-22-2014, 11:28 AM | #317 (permalink) |
A True Z Fanatic
Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141521 |
i also use a disposable paper funnel for topping off... too lazy to clean the plastic funnel each time.
wife suggested i buy icecone cones and cut the bottom in the future to save cost. hahaha. |
09-22-2014, 11:31 AM | #320 (permalink) | |
A True Z Fanatic
Join Date: Jul 2014
Location: bouncin on tigga
Posts: 8,062
Drives: '12 Z
Rep Power: 9435 |
Quote:
I'll add a cup of oil (or so) check back after to see the level and rinse& repeat until closer to the top hole. Once I get my maintanence I'll see which oil they use (or make a request to either m1 or castrol since either are readily available) and keep it consistent. Always nice to have that peace-of-mind. |
|
09-22-2014, 11:41 AM | #322 (permalink) | |
A True Z Fanatic
Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141521 |
Quote:
yah, the owners' manual apparently says to measure 15min after shutting off car or something (so i read on someone's post, i think), but i just check every weekend before starting the car. my Z is always hooked up to the battery manager during the weekday so the hood is unlocked and partially open on the secondary latch. so it's very easy for me to check the oil level anyway. i also check other vital fluid levels from passenger side to driver side... steering, coolant, brake, clutch. steering and coolant should be in the mid to high mark, brake can be anywhere within the max/min (level decreases as your pads wear), and clutch fluid should be at the max at all times. tattle tale sign for csc failure is if you notice the clutch fluid level dropping. |
|
09-22-2014, 11:49 AM | #323 (permalink) | |
A True Z Fanatic
Join Date: Jul 2014
Location: bouncin on tigga
Posts: 8,062
Drives: '12 Z
Rep Power: 9435 |
Quote:
|
|
09-22-2014, 11:49 AM | #324 (permalink) |
A True Z Fanatic
Join Date: Apr 2010
Location: Battle Lake MN
Age: 64
Posts: 183,964
Drives: 370Z 240Z
Rep Power: 2684736 |
__________________
Koni|Swift|Michelin|Motordyne|Berk|RJM Performance|Gates|SPL|Motul|Technafit|Ate Super Blue|Hawk
Tommy Kaira|Momo|Optima|Hella|Hotchkis|Red Line|ZSpeed|Stillen|B&M|H&R |
09-22-2014, 11:49 AM | #325 (permalink) |
A True Z Fanatic
Join Date: Apr 2010
Location: Battle Lake MN
Age: 64
Posts: 183,964
Drives: 370Z 240Z
Rep Power: 2684736 |
Son Taylor ---
__________________
Koni|Swift|Michelin|Motordyne|Berk|RJM Performance|Gates|SPL|Motul|Technafit|Ate Super Blue|Hawk
Tommy Kaira|Momo|Optima|Hella|Hotchkis|Red Line|ZSpeed|Stillen|B&M|H&R |
09-22-2014, 11:54 AM | #326 (permalink) | |
A True Z Fanatic
Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141521 |
Quote:
i think the best suggestion i can make on preventing csc failure is to go easy on the clutch. minimize smashing the clutch-in and clutch dumps. i dont baby the clutch at all, just easy clutch-in and out. G35C's are also prone to csc failures (nissan apparently didnt see alarming rates of failures i suppse)..but i seriously doubt mines going any time soon. also replacing the clutch fluid every now and then appears to help the life of the csc. the cylinder is tiny compared to wat you're doing to the entire car... it's not going to hold up to much abuse. |
|
09-22-2014, 12:16 PM | #327 (permalink) |
A True Z Fanatic
Join Date: Jul 2014
Location: bouncin on tigga
Posts: 8,062
Drives: '12 Z
Rep Power: 9435 |
Yea I don't pop the clutch out (intentionally atleast)... has slipped on a few occasions but driver error
I did smash the clutch a few times when I started especially when revving hard, but learned quickly that it doesn't matter how fast I push the pedal, the clutch will do it's job. |
09-22-2014, 12:19 PM | #328 (permalink) | |
A True Z Fanatic
Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141521 |
Quote:
|
|
09-22-2014, 12:33 PM | #329 (permalink) | |
A True Z Fanatic
Join Date: Jul 2014
Location: bouncin on tigga
Posts: 8,062
Drives: '12 Z
Rep Power: 9435 |
Quote:
Although I have noticed on occasion when fully pressing the clutch / half way that there is a bit of chatter/clucking/knocking sounds and feel in the pedal. Sometimes it happens, sometimes it doesnt... usually after riding the clutch a bit going up a hill or when I'm about to park my car. Engagement is still good, will stall in first (oops moment this weeked) when on the brakes and off the clutch... damn my amateur hour was supposed to be over today |
|
09-22-2014, 12:43 PM | #330 (permalink) | |
A True Z Fanatic
Join Date: Aug 2009
Location: N/A
Posts: 76,801
Drives: N/A
Rep Power: 141521 |
Quote:
|
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
The New "What did you do with your Z today" (with off topic replies) XIII | JARblue | The Lounge (Off Topic) | 10011 | 08-04-2014 05:16 PM |
The New "What did you do with your Z today" (with off topic replies) XII | eastwest2300 | The Lounge (Off Topic) | 10000 | 05-27-2014 11:28 AM |
The New "What did you do with your Z today" (with off topic replies) VIII | JARblue | The Lounge (Off Topic) | 10016 | 11-10-2013 12:21 PM |
The New "What did you do with your Z today" (with off topic replies) II | happytheman | The Lounge (Off Topic) | 10004 | 12-24-2012 08:31 PM |
The New "What did you do with your Z today" (with off topic replies) | happytheman | The Lounge (Off Topic) | 10265 | 11-01-2012 12:15 AM |