The New "What did you do with your Z today" (with off topic replies) XII

happytheman · 05-05-2014, 09:09 PM

Ok...I already know what Onzy thinks (since he has SPC in his siggy)..but SPC...good stuff, or spend the extra on SPL if rear camber correction is required post Swift install?

happytheman · 05-05-2014, 09:11 PM

Next question: are you all ok with reusing clay if it's not too badly soiled? I used a bit of Griots Paint Cleaning Clay on my hood yesterday..and it wasn't too bad, so I wrapped it in Saran Wrap and figured I'd ask the group for their thoughts.

onzedge · 05-05-2014, 09:13 PM

Quote:

Originally Posted by happytheman

Ok...I already know what Onzy thinks (since he has SPC in his siggy)..but SPC...good stuff, or spend the extra on SPL if rear camber correction is required post Swift install?

I am actually swapping my SPC out for SPL.

madwi · 05-05-2014, 09:14 PM

Quote:

Originally Posted by happytheman

Next question: are you all ok with reusing clay if it's not too badly soiled? I used a bit of Griots Paint Cleaning Clay on my hood yesterday..and it wasn't too bad, so I wrapped it in Saran Wrap and figured I'd ask,the group for their thoughts.

I usually just refold the clay into it self to expose clean areas. Did you rip a chunk off the bar and just use that?

happytheman · 05-05-2014, 09:18 PM

Quote:

Originally Posted by madwi

I usually just refold the clay into it self to expose clean areas. Did you rip a chunk off the bar and just use that?

Just ripped off a chunk about the size of a large gumball.

happytheman · 05-05-2014, 09:19 PM

Quote:

Originally Posted by onzedge

I am actually swapping my SPC out for SPL.

Oh RLY? Now why would you be doing that, my friend?

Next question: toe bolts...I'm assuming you has them?

onzedge · 05-05-2014, 09:23 PM

Quote:

Originally Posted by happytheman

Oh RLY? Now why would you be doing that, my friend?

Next question: toe bolts...I'm assuming you has them?

I am in spec on the toe, so I did not have to use them.

I picked up a set of SPL cheap so I am swapping them out as soon as I am home on a Friday, which may be never at this rate.

The SPC are fine, but they have been known to break under hard use. It is rare. I would be keeping them if I had not got that smoking deal on the SPL's.

onzedge · 05-05-2014, 09:23 PM

Who owes me a Rep?

Be honest, now. Search your feelings.

madwi · 05-05-2014, 09:30 PM

Quote:

Originally Posted by happytheman

Just ripped off a chunk about the size of a large gumball.

Toss it if its showing black areas. A piece that small is no big loss and not worth it potentially wrecking all your hard work.

jlo370z · 05-05-2014, 09:35 PM

Quote:

Originally Posted by onzedge

Who owes me a Rep?

Be honest, now. Search your feelings.

just checked cant send yet. should be soon though

happytheman · 05-05-2014, 09:43 PM

Repppp dropped! Carlitos and Nis...I owe you guys.

onzedge · 05-05-2014, 09:45 PM

Quote:

Originally Posted by happytheman

Repppp dropped! Carlitos and Nis...I owe you guys.

kenchan · 05-05-2014, 09:50 PM

Quote:

Originally Posted by happytheman

Ok...I already know what Onzy thinks (since he has SPC in his siggy)..but SPC...good stuff, or spend the extra on SPL if rear camber correction is required post Swift install?

not sure. b15's rear camber was -2.9 max at 0.6 toe in or something, which isn't that terrible. i'd do the spring install and see where it takes you. you're going to end up doing a few alignments anyway to dial-in your setup.

Quote:

Originally Posted by happytheman

Next question: are you all ok with reusing clay if it's not too badly soiled? I used a bit of Griots Paint Cleaning Clay on my hood yesterday..and it wasn't too bad, so I wrapped it in Saran Wrap and figured I'd ask the group for their thoughts.

yep, i re-use my clay if it's not dirty. i usually just roll it up into a ball, place it in my clay jar, and spray into the jar before i close the lid.

onzedge · 05-05-2014, 09:53 PM

Quote:

Originally Posted by kenchan

not sure. b15's rear camber was -2.9 max at 0.6 toe in or something, which isn't that terrible. i'd do the spring install and see where it takes you. you're going to end up doing a few alignments anyway to dial-in your setup.

yep, i re-use my clay if it's not dirty. i usually just roll it up into a ball, place it in my clay jar, and spray into the jar before i close the lid.

happytheman · 05-05-2014, 10:10 PM

Quote:

Originally Posted by kenchan

not sure. b15's rear camber was -2.9 max at 0.6 toe in or something, which isn't that terrible. i'd do the spring install and see where it takes you. you're going to end up doing a few alignments anyway to dial-in your setup.

yep, i re-use my clay if it's not dirty. i usually just roll it up into a ball, place it in my clay jar, and spray into the jar before i close the lid.

Thanks for the sound advice, as always. You may not cotton to all that lowering nonsense, but you do have a depth of knowledge about it.

05-05-2014, 09:09 PM	#6736 (permalink)
happytheman A True Z Fanatic Join Date: Apr 2010 Location: Florida Posts: 10,737 Drives: MB 6M Tour/Sport Z34 Rep Power: 1822	Ok...I already know what Onzy thinks (since he has SPC in his siggy)..but SPC...good stuff, or spend the extra on SPL if rear camber correction is required post Swift install? onzedge likes this. __________________ --Brantly-- *PowderCoating by Mike/Stillen/PWJDM/Shine Auto/NST* GTR/Michelin /Fast Intentions/Evo-R/Mobil 1/Motul/Z1 https://facebook.com/CentralFloridaZClub Last edited by happytheman; 05-05-2014 at 09:12 PM.

05-05-2014, 09:11 PM	#6737 (permalink)
happytheman A True Z Fanatic Join Date: Apr 2010 Location: Florida Posts: 10,737 Drives: MB 6M Tour/Sport Z34 Rep Power: 1822	Next question: are you all ok with reusing clay if it's not too badly soiled? I used a bit of Griots Paint Cleaning Clay on my hood yesterday..and it wasn't too bad, so I wrapped it in Saran Wrap and figured I'd ask the group for their thoughts. __________________ --Brantly-- *PowderCoating by Mike/Stillen/PWJDM/Shine Auto/NST* GTR/Michelin /Fast Intentions/Evo-R/Mobil 1/Motul/Z1 https://facebook.com/CentralFloridaZClub Last edited by happytheman; 05-05-2014 at 09:20 PM.

05-05-2014, 09:23 PM	#6743 (permalink)
onzedge A True Z Fanatic Join Date: Apr 2010 Location: Battle Lake MN Age: 64 Posts: 183,964 Drives: 370Z 240Z Rep Power: 2684736	Who owes me a Rep? Be honest, now. Search your feelings. __________________ Koni\|Swift\|Michelin\|Motordyne\|Berk\|RJM Performance\|Gates\|SPL\|Motul\|Technafit\|Ate Super Blue\|Hawk Tommy Kaira\|Momo\|Optima\|Hella\|Hotchkis\|Red Line\|ZSpeed\|Stillen\|B&M\|H&R

05-05-2014, 09:43 PM	#6746 (permalink)
happytheman A True Z Fanatic Join Date: Apr 2010 Location: Florida Posts: 10,737 Drives: MB 6M Tour/Sport Z34 Rep Power: 1822	Repppp dropped! Carlitos and Nis...I owe you guys. __________________ --Brantly-- *PowderCoating by Mike/Stillen/PWJDM/Shine Auto/NST* GTR/Michelin /Fast Intentions/Evo-R/Mobil 1/Motul/Z1 https://facebook.com/CentralFloridaZClub

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The New "What did you do with your Z today" (with off topic replies) XI	eastwest2300	The Lounge (Off Topic)	10000	03-27-2014 04:55 PM
The New "What did you do with your Z today" (with off topic replies) VIII	JARblue	The Lounge (Off Topic)	10016	11-10-2013 12:21 PM
The New "What did you do with your Z today" (with off topic replies) VI	Pintsize725	The Lounge (Off Topic)	10005	07-30-2013 07:57 AM
The New "What did you do with your Z today" (with off topic replies) II	happytheman	The Lounge (Off Topic)	10004	12-24-2012 08:31 PM
The New "What did you do with your Z today" (with off topic replies)	happytheman	The Lounge (Off Topic)	10265	11-01-2012 12:15 AM