| JARblue |
08-01-2013 09:07 AM |
Couple of things on the Z:
I hand polished part of the roof last night. It definitely takes some elbow grease, and I think I will be borrowing my buddy's porter cable RO to do larger areas (I know... many of you right now are saying "DUH!" :icon17:). I went at it with a Meguiar's Compound pad and their Rubbing Compound (for hand use only). I focused on a grouping of three specific water spots and a very light but several inches long scratch. I put down three applications, starting with very light pressure, then light pressure, then medium pressure. I either didn't use enough product or I was rubbing too much because it was pretty difficult to remove after each application - I'm chalking it up to lack of experience. When I was done with the Rubbing Compound, I moved over to the Polishing Compound (also for hand use only) and their polishing pad. I did one application of this before waxing. I am pleased with the results as I removed about 60% of the scratch and 80% of the water spots. I suspect a good DA will take care of them no problem. My main question is the best product to use. Does anyone know of a good resource that compares the different levels of abrasiveness in various products for paint correction?
Next, this morning I pushed in the clutch pedal to start the car and it seemed to be very light with a shorter than normal travel distance :confused: I didn't think too much of it, and wanted to see how it drove. However, I proceeded to nearly stall backing out of the garage and then did stall shifting into first :facepalm: For the record, I have only stalled this car twice previously (once within the first two weeks of purchase and most recently, last fall when I was on a very steep incline and not paying enough attention). So I pulled back into the driveway and checked a few things. The first thing I noticed is my clutch fluid is low. I will fill that up later today, but I'm worried that it's not the culprit (can anyone say CSC? I bet Alchemy can :ugh2:). Are these symptoms likely a result of low clutch fluid? I've never had this particular problem any of my other MT cars.
Last and definitely least, I found out where a little plastic bolts goes that Melody found on the Z floorboard just a few weeks after purchase. I've had it sitting around without a clue as to where it goes. Well this morning when I was checking out the clutch pedal assembly, I noticed that there is a missing bolts for the dead pedal that holds it to the firewall. I didn't bother to reinstall it yet, but I will today or tomorrow :tup:
|
