The New “What did you do with your Z today” (with off topic replies) XXXX

vtec to vvel · 05-26-2023, 08:00 PM

Quote:

Originally Posted by JARblue

I actually had some problems with the CMC even with the OEM CSC installed. But I don't think they were related to the slave in any way. The most recent failure was due to an improperly adjusted clutch pedal and that was a while ago before the CMAK install. I also used to have a bad habit of stabbing at the clutch pedal and holding it all the way to the floor, which stresses the internal seals. I got the pedal adjusted and corrected my pedal habits; outside of those issues, I haven't had any trouble with the OEM CMC. I've considered getting one of the heavy duty ones, but it's working now and I've messed with it enough.

Much like how there's no sense in replacing the OEM CSC with another OEM CSC, I guess I'm worried if the OEM CMC is also prone to failure and wondering if the CMC should be replaced with aftermarket or if the OEM CMC would suffice.

What a headache and PITA this CSC causes

JARblue · 05-26-2023, 08:06 PM

With proper installation, the OEM CMC is just fine.

vtec to vvel · 05-26-2023, 08:06 PM

Quote:

Originally Posted by eastwest2300

how do you plan on lifting the car and dropping the transmission?

I have a high-capacity low-rise scissor lift for getting the car up. One of my buddies has a tranny jack that I can use.

When I traded my A7 for M6, I was preparing for the dreaded CSC and bought all the tools needed, minus the high-capacity low-rise scissor lift (got this for free).

vtec to vvel · 05-26-2023, 08:08 PM

Quote:

Originally Posted by JARblue

With proper installation, the OEM CMC is just fine.

I'll buy you 2 ice creams if you come to FL and help me replace

And that travel ban is fake political news/stunt

To put your mind at ease, I'm Asian, which I know you like to report for whatever reason, but nobody messes with me so I think you should be good

JARblue · 05-26-2023, 08:10 PM

I dropped my transmission on jack stands. Couldn't even get the transmission out from under the car. We just slid it down the tunnel toward the back of the car to make room to work. The worst part was disconnecting and reconnecting the sensor on the top of the transmission - had to go through the engine bay to get it.

eastwest2300 · 05-26-2023, 08:11 PM

Quote:

Originally Posted by vtec to vvel

I'll buy you 2 ice creams if you come to FL and help me replace

And that travel ban is fake political news/stunt

To put your mind at ease, I'm Asian, which I know you like to report for whatever reason, but nobody messes with me so I think you should be good

If Jar made the trip out to help you, I would strongly consider making the drive up to lend a hand too.. small caveat though, Nismo (my dog) would be coming with me..

vtec to vvel · 05-26-2023, 08:13 PM

Quote:

Originally Posted by JARblue

I dropped my transmission on jack stands. Couldn't even get the transmission out from under the car. We just slid it down the tunnel toward the back of the car to make room to work. The worst part was disconnecting and reconnecting the sensor on the top of the transmission - had to go through the engine bay to get it.

I've also read about 2 bolts on top of the tranny that is a PITA to get to. Is it totally necessary to reconnect these or can I skip these 2? The amount of energy/effort for 2 lousy bolts just doesn't seem worth the trouble, and I find it hard to believe that 2 bolts is what's holding the tranny in place.

JARblue · 05-26-2023, 08:14 PM

Quote:

Originally Posted by vtec to vvel

And that travel ban is fake political news/stunt

I dunno about fake news. I've seen the policies that FL has proposed and adopted. IMO the advisory should be for those living in or thinking about moving to FL. And the advisory should simply read: DON'T

I'm just kidding around of course. That travel advisory doesn't affect me. I'm a straight, white male

vtec to vvel · 05-26-2023, 08:17 PM

Quote:

Originally Posted by eastwest2300

If Jar made the trip out to help you, I would strongly consider making the drive up to lend a hand too.. small caveat though, Nismo (my dog) would be coming with me..

No worries, I have a Korean Jindo dog that would keep him company

JARblue · 05-26-2023, 08:17 PM

Quote:

Originally Posted by vtec to vvel

I've also read about 2 bolts on top of the tranny that is a PITA to get to. Is it totally necessary to reconnect these or can I skip these 2? The amount of energy/effort for 2 lousy bolts just doesn't seem worth the trouble, and I find it hard to believe that 2 bolts is what's holding the tranny in place.

I don't recall having any issues getting to the bolts. We had all the necessary swivels, adapters, and extensions and such. The toughest part was getting the threads started when reinstalling.

vtec to vvel · 05-26-2023, 08:18 PM

Quote:

Originally Posted by JARblue

I dunno about fake news. I've seen the policies that FL has proposed and adopted. IMO the advisory should be for those living in or thinking about moving to FL. And the advisory should simply read: DON'T

I'm just kidding around of course. That travel advisory doesn't affect me. I'm a straight, white male

Whatever this travel ban is about, I guess I get a pass for having a white wifey

JARblue · 05-26-2023, 08:19 PM

Wish I could help, but I've got a M3 still torn apart in my garage. I can't be traveling across the country to help other people work on their cars when I don't even have the time and energy for my own

JARblue · 05-26-2023, 08:20 PM

Ok I'm leaving the office finally. Have a lovely Friday evening and a wonderful weekend everyone

vtec to vvel · 05-26-2023, 08:21 PM

Quote:

Originally Posted by JARblue

Wish I could help, but I've got a M3 still torn apart in my garage. I can't be traveling across the country to help other people work on their cars when I don't even have the time and energy for my own

All good man. And I'm sure EW could help you out with the M3, since he owns a bmw also.

eastwest2300 · 05-26-2023, 08:26 PM

Quote:

Originally Posted by vtec to vvel

All good man. And I'm sure EW could help you out with the M3, since he owns a bmw also.

05-26-2023, 08:06 PM	#11792 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	With proper installation, the OEM CMC is just fine. eastwest2300 and vtec to vvel like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

05-26-2023, 08:10 PM	#11795 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	I dropped my transmission on jack stands. Couldn't even get the transmission out from under the car. We just slid it down the tunnel toward the back of the car to make room to work. The worst part was disconnecting and reconnecting the sensor on the top of the transmission - had to go through the engine bay to get it. eastwest2300 and vtec to vvel like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

05-26-2023, 08:19 PM	#11802 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	Wish I could help, but I've got a M3 still torn apart in my garage. I can't be traveling across the country to help other people work on their cars when I don't even have the time and energy for my own FL 4Motion, eastwest2300 and vtec to vvel like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

05-26-2023, 08:20 PM	#11803 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	Ok I'm leaving the office finally. Have a lovely Friday evening and a wonderful weekend everyone eastwest2300 and vtec to vvel like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The New “What did you do with your Z today” (with off topic replies) XXXIX	Spoiler	The Lounge (Off Topic)	10010	07-02-2021 01:02 PM
The new “what did you do to your Z today” (with off topic replies) XXXVIII	Spoiler	The Lounge (Off Topic)	9999	12-23-2020 07:10 AM
The New “What did you do with your Z today” (with off topic replies) XXXVI	Spoiler	The Lounge (Off Topic)	9999	06-10-2020 01:40 AM
The New “What did you do with your Z today” (with off topic replies) XXXV	Spoiler	The Lounge (Off Topic)	9999	04-08-2020 09:47 PM
The New “What did you do with your Z today” (with off topic replies) XXXIV	Spoiler	The Lounge (Off Topic)	9999	01-24-2020 06:42 PM