The New “What did you do with your Z today” (with off topic replies) XXXVII

Ghostvette · 08-18-2020, 09:06 AM

Low 60s this morning, so I

the Z today

Looks like I have a new project, engineered floors in the family room...

240 sq. feet, a rectangular room (well, at least as 'square' as they get built these days), there's carpet on concrete, so the only issue might be a concrete floor that's not level.

Now to move the desk, a recliner and a 75 (?) gallon aquarium.....

Spooler · 08-18-2020, 09:13 AM

Quote:

Originally Posted by jchammond

I did; as the E load-range tire is factory sizes for that trailer & adequate,pending quality of tires.
The Goodyear Endurance Trailer service tires are rated just over 2800# each@80psi

We haven’t had trouble with those on our cargo trailers

The tires that I was referring to on Spoolers horse trailer are most likely 235/85/R16’s, as those are available in 14ply (G-load range) & HAF

Those are on a few deck over trailers that see off road action, bounce off curbs & errthing else....just abused

Run those tires at max cold tire pressure & as level as possible, as Spooler mentioned.
Measure the ground clearance on each side at front & rear vs using a level....+ a tick high is better in front vs being low up front; that will wag the dog

Properly loading is another thing; keep weight forward & let your big truck handle so of the spread

I currently have a small 5x9 tag trailer w/ ShingShang’ s on it & a Goodride spare from Tractor Supply..ST205/75/15 ... I’m thinking C load range (6ply)

No where the weight you’re hauling; but you’ll be fine with the GY’s,as your hubs can’t hardly withstand the increased weight of the 14-ply 16” wheel/tire combo

I poked around looking at tires for my car trailer yesterday. Best one is the Goodyear Endurance and they are rated for 87mph. Suck it up and get the load range E's but they do offer the load range D's. They are cheap compared to the Goodyear G614.
I never set to max PSI unless I am loaded at the limit. I set at 10psi lower than max for normal use. Oh yeah, weigh your chit on a certified scale loaded. That way you know what you have weight wise per axle.

JARblue · 08-18-2020, 09:15 AM

Quote:

Originally Posted by JARblue

Alternator on the Lexus is replaced. Removal and reinstallation took about an hour. It was almost like I knew what I was doing

Starts and runs like a champ again

Well shìt... I guess that means I have to go into the office now

JARblue · 08-18-2020, 09:16 AM

Have a wonderful Tuesday, everyone

Spooler · 08-18-2020, 09:17 AM

Quote:

Originally Posted by JARblue

Have a wonderful Tuesday, everyone

If my car get's tuned I will.

JLarson · 08-18-2020, 09:21 AM

Quote:

Originally Posted by Ghostvette

240 sq. feet, a rectangular room (well, at least as 'square' as they get built these days), there's carpet on concrete, so the only issue might be a concrete floor that's not level.

How much of an issue with leveling are you talking? You could try self leveling compound to smooth things out. My buddy had a floor that actually dropped 1.5" from one side to the other, and we were able to take a lot of that out using self leveling compound and the underlayment.

Leingod · 08-18-2020, 09:25 AM

Just signed the paperwork to back out of the house contract. Sellers already have it back on the market now asking 85k. It's still 20k to high for all the foundation work needed. Morons.....

JARblue · 08-18-2020, 09:29 AM

Quote:

Originally Posted by Spooler

If my car get's tuned I will.

Very nice! You'll be blasting around in no time! Hope the knee stays strong on the drive to go pick up

madwi · 08-18-2020, 09:32 AM

Quote:

Originally Posted by JARblue

Very nice! You'll be blasting around in no time! Hope the knee stays strong on the drive to go pick up

Ghostvette · 08-18-2020, 09:35 AM

Quote:

Originally Posted by JLarson

How much of an issue with leveling are you talking? You could try self leveling compound to smooth things out. My buddy had a floor that actually dropped 1.5" from one side to the other, and we were able to take a lot of that out using self leveling compound and the underlayment.

I won't know until we get the carpet & what's left of the pad up. I think we'll be okay, this is very old carpet and we think the previous owners took part of the pad out in places.

Every time Stanley Steemer comes out to clean that carpet, a little more pad disappears..... .

Zoren 370 · 08-18-2020, 09:45 AM

Quote:

Originally Posted by Spooler

I poked around looking at tires for my car trailer yesterday. Best one is the Goodyear Endurance and they are rated for 87mph. Suck it up and get the load range E's but they do offer the load range D's. They are cheap compared to the Goodyear G614.
I never set to max PSI unless I am loaded at the limit. I set at 10psi lower than max for normal use. Oh yeah, weigh your chit on a certified scale loaded. That way you know what you have weight wise per axle.

Ok if I pass by a weigh station at I75 could I get a reading how much weight my trailer load is it for free or I need to pay?

Zoren 370 · 08-18-2020, 09:48 AM

Quote:

Originally Posted by Spooler

I poked around looking at tires for my car trailer yesterday. Best one is the Goodyear Endurance and they are rated for 87mph. Suck it up and get the load range E's but they do offer the load range D's. They are cheap compared to the Goodyear G614.
I never set to max PSI unless I am loaded at the limit. I set at 10psi lower than max for normal use. Oh yeah, weigh your chit on a certified scale loaded. That way you know what you have weight wise per axle.

For now I got National its 10 ply at 80psi max
The GY has to be ordered.
They recommend Heartland same rating as GY but lot cheaper. Have you heared about this brands National, HeartLand? Looks like they are from Covid land too.

Rusty · 08-18-2020, 09:55 AM

Quote:

Originally Posted by Zoren 370

Ok if I pass by a weigh station at I75 could I get a reading how much weight my trailer load is it for free or I need to pay?

Truck stop would be your best bet. Have the car loaded in the trailer. Drive on the scale. Weight just the truck first with the trailer attached. Then weight both truck and trailer together. Then weight just the trailer with truck attached.

Rusty · 08-18-2020, 09:57 AM

Quote:

Originally Posted by Zoren 370

For now I got National its 10 ply at 80psi max
The GY has to be ordered.
They recommend Heartland same rating as GY but lot cheaper. Have you heared about this brands National, HeartLand? Looks like they are from Covid land too.

Stay away from ANY tire from China.

Zoren 370 · 08-18-2020, 10:12 AM

Quote:

Originally Posted by Rusty

Truck stop would be your best bet. Have the car loaded in the trailer. Drive on the scale. Weight just the truck first with the trailer attached. Then weight both truck and trailer together. Then weight just the trailer with truck attached.

Do they charge a fee for that?

08-18-2020, 09:06 AM	#7636 (permalink)
Ghostvette A True Z Fanatic Join Date: Aug 2013 Location: Shawnee KS Posts: 5,698 Drives: 15 Magma Red 6MT Rep Power: 2684377	Low 60s this morning, so I the Z today Looks like I have a new project, engineered floors in the family room... 240 sq. feet, a rectangular room (well, at least as 'square' as they get built these days), there's carpet on concrete, so the only issue might be a concrete floor that's not level. Now to move the desk, a recliner and a 75 (?) gallon aquarium..... Rusty, Hotrodz, madwi and 6 others like this. __________________ 2015 Magma Red 6MT Sport Tech/2012 Fairlady MB 6MT Base (RIP 08032018)https://www.nicoclub.com/FSM/370Z/Coupe/

08-18-2020, 09:16 AM	#7639 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,450 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	Have a wonderful Tuesday, everyone Rusty, Hotrodz, sx moneypit and 4 others like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

08-18-2020, 09:25 AM	#7642 (permalink)
Leingod A True Z Fanatic Join Date: Mar 2015 Location: Some Place Cold Posts: 16,060 Drives: In Circles Rep Power: 2684396	Just signed the paperwork to back out of the house contract. Sellers already have it back on the market now asking 85k. It's still 20k to high for all the foundation work needed. Morons..... FL 4Motion, JARblue, Rusty and 8 others like this. __________________ I AM FLOOF! SOMEBODY FLOOF MY HORN!! ALL HAIL THE FLOOF!!I JUST FLOOFED ON THE FLOOR

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The New "What did you do with your Z today" (with off topic replies) Cooking Edition	Leingod	The Lounge (Off Topic)	319	09-28-2021 11:10 PM
The New “What did you do with your Z today” (with off topic replies) XXXVI	Spoiler	The Lounge (Off Topic)	9999	06-10-2020 01:40 AM
The New “What did you do with your Z today” (with off topic replies) XXXV	Spoiler	The Lounge (Off Topic)	9999	04-08-2020 09:47 PM
The New “What did you do with your Z today” (with off topic replies) XXXIV	Spoiler	The Lounge (Off Topic)	9999	01-24-2020 06:42 PM