The New “What did you do with your Z today” (with off topic replies) XXXIV

Rusty · 12-04-2019, 07:53 AM

I'z up.

Checked to see which parts or hurting, and which parts ain't. Just the left foot with the pins in it is bothering me. After that, feel pretty good.

Rusty · 12-04-2019, 07:59 AM

Woke up to about 1 inch of global warming. Everything is covered, but no the roads. Ground is still to warm for the snow not to melt there.

Reading one of my agr reports last night. It's still snowing in parts of Australia.

And it's their summer.

onzedge · 12-04-2019, 07:59 AM

Quote:

Originally Posted by Rusty

I'z up.

Checked to see which parts or hurting, and which parts ain't. Just the left foot with the pins in it is bothering me. After that, feel pretty good.

JLarson · 12-04-2019, 08:01 AM

Morning all! Woke up to light snow this morning, so truck was used again. Plenty of meetings today, but I'll get through them.

Spoiler, glad you're through this phase! Prayers are with you sir.

Rusty · 12-04-2019, 08:05 AM

Quote:

Originally Posted by onzedge

sx moneypit · 12-04-2019, 08:13 AM

Quote:

Originally Posted by Leingod

Might buy a 2016 Chevy cruze.

Note to Mr Leingod.Do not buy a Chevy Cruze.They are a POS.

jchammond · 12-04-2019, 08:14 AM

Got one of these boosting off the other one, wanna guess which

Yesterday around lunchtime

sx moneypit · 12-04-2019, 08:14 AM

And,good morning everyone!

Glad to see Mr Spoiler is through with his treatments!

-ZS-Carpenter · 12-04-2019, 08:16 AM

Quote:

Originally Posted by BettyZ

At a loss on how to frame/ceiling this corner. I have separate cut OSB to cover the rafters below the ceiling level. But cant figure out how to extend the ceiling to this corner. Thoughts?

Sent from my SM-G955U using Tapatalk

That's a rough one. With the hip being thicker than the rafters we would normally fir the rafters to bury the hip before sheeting the rafters. Unless you start over on the angled sections the hip will just be left exposed. Attach a couple short 2x2 to the hip between the rafters to get the end of the sheet nailed tight. You might have to cut the bottom of the last 2 rafters off. I can't tell if it's camera angle or if they are way out of plane. May need a little butchery with a sawzall to clean out the corner.

To get a backer in the corner of the flat just cut a 45* on a 2x2 or flat 2x4 and run it from the ceiling joist into the hip at the point the flat part planes through. Might need to do one both ways. Don't worry about it being right at the end of the sheet. It can be back a couple inches if need be to make it fit.

onzedge · 12-04-2019, 08:21 AM

Rep

onzedge · 12-04-2019, 08:22 AM

Freely

onzedge · 12-04-2019, 08:22 AM

onzedge · 12-04-2019, 08:22 AM

Quote:

Originally Posted by sx moneypit

And,good morning everyone!

Glad to see Mr Spoiler is through with his treatments!

sx moneypit · 12-04-2019, 08:27 AM

Quote:

Originally Posted by onzedge

StormWhite · 12-04-2019, 08:28 AM

Quote:

Originally Posted by old guy

Spoiler, you look great brother

So great to hear you're feeling good too !
Looking good, feeling good, brother you got this

12-04-2019, 07:53 AM	#5311 (permalink)
Rusty Ronin Samurai - Assassin Join Date: Dec 2011 Location: Fayettenam,Pennsyltucky Age: 68 Posts: 35,286 Drives: 2011 Nismo GM 6M Rep Power: 2684438	I'z up. Checked to see which parts or hurting, and which parts ain't. Just the left foot with the pins in it is bothering me. After that, feel pretty good. Hotrodz, Spooler, jchammond and 3 others like this. __________________ 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html

12-04-2019, 08:01 AM	#5314 (permalink)
JLarson A True Z Fanatic Join Date: Jun 2017 Location: Media, PA Posts: 4,074 Drives: 14 Nissan 370z MR M6 Rep Power: 2684370	Morning all! Woke up to light snow this morning, so truck was used again. Plenty of meetings today, but I'll get through them. Spoiler, glad you're through this phase! Prayers are with you sir. Rusty, Hotrodz, sx moneypit and 4 others like this. __________________ 2014 370z Touring Sport Magma Red MT // BP Single Turbo 6467 // 63mm TB's // Z1 Ported Upper Mani // RJM Pedal // Zspeed Stage 3 Clutch // 526 WHP, 451 WTQ 2006 350z (Sold) // 1990 300zx (Sold) // 1985 300zx 2+2 (Sold)

12-04-2019, 08:14 AM	#5318 (permalink)
sx moneypit Premium Member Join Date: Oct 2014 Location: Memphis,Tn. Age: 68 Posts: 3,353 Drives: 2010 370Z PG 6 spd Rep Power: 2684371	And,good morning everyone!Glad to see Mr Spoiler is through with his treatments! onzedge, Hotrodz, jchammond and 4 others like this.

12-04-2019, 08:21 AM	#5320 (permalink)
onzedge A True Z Fanatic Join Date: Apr 2010 Location: Battle Lake MN Age: 64 Posts: 183,964 Drives: 370Z 240Z Rep Power: 2684736	Rep sx moneypit likes this. __________________ Koni\|Swift\|Michelin\|Motordyne\|Berk\|RJM Performance\|Gates\|SPL\|Motul\|Technafit\|Ate Super Blue\|Hawk Tommy Kaira\|Momo\|Optima\|Hella\|Hotchkis\|Red Line\|ZSpeed\|Stillen\|B&M\|H&R

12-04-2019, 08:22 AM	#5321 (permalink)
onzedge A True Z Fanatic Join Date: Apr 2010 Location: Battle Lake MN Age: 64 Posts: 183,964 Drives: 370Z 240Z Rep Power: 2684736	Freely __________________ Koni\|Swift\|Michelin\|Motordyne\|Berk\|RJM Performance\|Gates\|SPL\|Motul\|Technafit\|Ate Super Blue\|Hawk Tommy Kaira\|Momo\|Optima\|Hella\|Hotchkis\|Red Line\|ZSpeed\|Stillen\|B&M\|H&R

12-04-2019, 08:22 AM	#5322 (permalink)
onzedge A True Z Fanatic Join Date: Apr 2010 Location: Battle Lake MN Age: 64 Posts: 183,964 Drives: 370Z 240Z Rep Power: 2684736	__________________ Koni\|Swift\|Michelin\|Motordyne\|Berk\|RJM Performance\|Gates\|SPL\|Motul\|Technafit\|Ate Super Blue\|Hawk Tommy Kaira\|Momo\|Optima\|Hella\|Hotchkis\|Red Line\|ZSpeed\|Stillen\|B&M\|H&R

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
The New "What did you do with your Z today" (with off topic replies) Cooking Edition	Leingod	The Lounge (Off Topic)	319	09-28-2021 11:10 PM
The New "What did you do with your Z today" (with off topic replies) XXIV	JARblue	The Lounge (Off Topic)	10059	08-17-2016 01:08 PM
The New "What did you do with your Z today" (with off topic replies) XXIII	eastwest2300	The Lounge (Off Topic)	10001	06-23-2016 10:21 AM
The New "What did you do with your Z today" (with off topic replies) XXII	eastwest2300	The Lounge (Off Topic)	10001	04-05-2016 09:15 PM