|
Regardless of jack used; make sure you get some quality jack stands or some treated wooden blocks (4x6,2x6,2x8's etc.), look close at jackstands; as most have vertical bottom plates &
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
07-27-2017, 02:33 AM
|
#16 (permalink) |
|
A True Z Fanatic
Join Date: Nov 2014
Location: South Carolina
Age: 58
Posts: 15,204
Drives: 13’ 370Z TS 7A/T
Rep Power: 2684395   |
Regardless of jack used; make sure you get some quality jack stands or some treated wooden blocks (4x6,2x6,2x8's etc.),
look close at jackstands; as most have vertical bottom plates & can sink in hot asphalt; as a few have flat corner bases & do not sink....still may want to place stand on a cut wooden square,from good treated 3/4" plywood or equavelant. This prevents damaging the asphalt & reduces slipping.
__________________
MazWorx built long block | FI-TT-100 Stage 2.75 | IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html |
|
|
|
07-27-2017, 02:36 AM
|
#17 (permalink) | |
|
A True Z Fanatic
Join Date: Sep 2012
Location: West Michigan
Posts: 31,410
Drives: Granma red Z
Rep Power: 2684429 |
Quote:
Esco low profile stands. 
|
|
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FOR SALE] Spare tire, jack, and wrench | Big J | Parts for sale (Private Classifieds) | 4 | 02-07-2017 10:47 AM |
| Jack/ jack stand procedure for lifting whole car | JerryK | Engine & Drivetrain | 5 | 04-16-2015 11:02 AM |
| Actual picture of 370z supported by jack stands on all 4 side jack pionts. | gsxr750 | Nissan 370Z General Discussions | 2 | 10-28-2012 03:42 PM |
| Jack Stands / Floor Jack | ronaldr911 | Exterior & Interior | 31 | 01-10-2012 02:50 PM |
| Impact Wrench Recommendations | daleks | DIY Section (Do-It-Yourself) | 21 | 08-06-2010 07:06 PM |
16Likes
Linear Mode
