Custom manifold/plenum/TBs

Originally Posted by ViCiouS

Thanks for the links guys. I'm fully prepared for lots of research and always considering advice/comments. Otherwise it would just turn into dumping money into a crap shoot as Kinetic did...

I do not have a flow bench yet, but I DO have full CFD tools.

One thing I haven't seen anywhere yet:
When a valve closes, obviously the air that was accelerating towards the opening will rebound and send a pressure wave back towards the plenum (the point of a plenum to start with). Ideally I would think the runners should be tuned so that this wave is reaching the plenum at the same moment an alternate valve is opening, thus creating a minimal boost in pressure going to the next cylinder. This may only be optimal at a peak rpm or range though as the pressure wave frequency changes based on rpm and vacuum.