Nissan 370Z Forum - Installing z1 intake manifold

Nissan 370Z Forum (http://www.the370z.com/)

- Intake/Exhaust (http://www.the370z.com/intake-exhaust/)

- - Installing z1 intake manifold (http://www.the370z.com/intake-exhaust/96783-installing-z1-intake-manifold.html)

jamesj1996

09-30-2014 02:24 PM

Installing z1 intake manifold

how many pounds do the lugs need to torqued to? i tried downloading the manual but my computer wont let me open it...can someone find out for me

wanker

09-30-2014 02:27 PM

E-mail Z1 directly. They are very good at answering questions, usually within 24 hours.

exsanity

09-30-2014 02:32 PM

I would say that it is the same as the torque required on the stock manifold.

jamesj1996

09-30-2014 02:39 PM

yeah but idk that...and when i called they jus sent me the manual which i cant open

Chuck33079

09-30-2014 03:03 PM

There's a link to the factory service manual available on this site.

exsanity

09-30-2014 04:17 PM

Disclaimer: The following information is intended for reference material only. Refer to the Service Data and Specifications table "Tightening Torque" in the EM section of the applicable Factory Service Manual for your model year Z.

Quote:

Originally Posted by Service Manual

INTAKE MANIFOLD COLLECTOR
• If stud bolts were removed, install them and tighten to the torque specified below.

: 10.8 N·m (1.1 kg-m, 8 ft-lb)

• Tighten mounting bolts and nuts in numerical order as shown in the
figure.

As found in >this< post.

jamesj1996

09-30-2014 04:20 PM

Quote:

Originally Posted by exsanity (Post 2983952)

thanks so much and whats the order it needs to be in can u post a pic?

jamesj1996

09-30-2014 04:29 PM

nvm got it

kornflake7

09-30-2014 05:18 PM

its basically hand tight 8 ft lb is basically nothing if you do too much it can cause problems, it was the same way when installing spacer on my old 350

ANMVQ

09-30-2014 08:55 PM

I just followed the hand tight rule , I recheked after two days to make sure also.

2012z

10-01-2014 06:38 PM

Quote:

Originally Posted by jamesj1996 (Post 2983752)

how many pounds do the lugs need to torqued to? i tried downloading the manual but my computer wont let me open it...can someone find out for me

I am very interested in gains you pick up from this intake....please provide feedback once u get installed if u can. Thanks

ANMVQ

10-02-2014 07:12 AM

its there, WTQ is up I made some runs a few weeks back, Wasn't happy about the place cause they didn't set the dyno up for AWD and almost blew my tcase.

All times are GMT -5. The time now is 10:42 AM.