Suggestions for Velocity Stacks?

SouthArk370Z · 05-22-2014, 07:03 AM

Quote:

Originally Posted by Jordo!

... So, my thinking is: Bellmouth + slight narrowing of inlet should smooth air and also speed up flow, improving responsiveness and low speed power, while maintaining OEM ID before the MAF should keep measurements accurate without needing any re-scaling in uprev.

On the other hand, any narrowing at the inlet could simply kill power everywhere, especially up top... or, I might break even up top due to the overall flow benefits, and just gain down low.

Or nothing will happen or it will run like ****. Oh how I wish I knew enough of the right math to figure this one out...

Anyone have any thoughts on this one...?

The increase in velocity due to a narrowing of the duct doesn't do you any good. The velocity decreases as soon as the duct gets bigger again. It will actually reduce the flow.

Since the sensor is measuring mass flow, there shouldn't be any need for re-scaling.

The math for figuring the loss due to narrowing of the duct is pretty straightforward - it's just an orifice. Flowrate Calculation for an Orifice Flowmeter looks like a good place to start. You will probably need a manometer or other differential pressure measuring device.

Figuring loss due to turbulence is much too complicated for me.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Custom intake setup -- Stillen G3's, Velocity Stacks, Custom Front Crash Beam, pics	'10Anamoly	Intake/Exhaust	26	02-14-2015 10:59 AM
How the 370z stacks up: Dollar / Horsepower	osbornsm	Nissan 370Z General Discussions	21	09-12-2013 09:21 PM
Velocity MOD1 by UAM	Timothy@UAM	Body Interior/Exterior	72	10-20-2011 10:37 AM
Sugar Stacks	frost	The Lounge (Off Topic)	4	06-20-2009 10:00 PM