|
the piece in the photos posted above was scrapped. After I machine out most of the runners inside, I could see that the ports were just slightly off. Initial measurements
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
02-23-2014, 11:58 PM
|
#1 (permalink) |
|
A True Z Fanatic
Join Date: Mar 2009
Location: Chicago
Posts: 3,669
Drives: 370
Rep Power: 974724   |
the piece in the photos posted above was scrapped. After I machine out most of the runners inside, I could see that the ports were just slightly off. Initial measurements were CLOSE but not dead on. I started a new one from scratch yesterday. This is much closer, within range for final hand porting. I will measure off it to dial in the next one even better.. but I will use this one.
Getting close to starting an official thread on this and asking for feedback, suggestions, concerns, etc... But not just yet. I want to get a little deeper in. For now, I have to set it aside until next weekend as I have fuel pump modules to design for late Vipers and the 90-95 300zx this week. |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intake manifold project | Dwnshift | Intake/Exhaust | 119 | 05-17-2015 02:37 AM |
| Z1 Motorsports: Metal HR/VHR Manifold 3 Bolt Gasket | John@Z1 | Exhaust/Intake | 27 | 09-09-2013 06:40 PM |
| ID this intake manifold | Japanjay | Intake/Exhaust | 5 | 07-27-2013 07:31 PM |
| [FOR SALE] OEM intake manifold | seymore4 | Parts for sale (Private Classifieds) | 5 | 02-24-2012 06:17 PM |
| gtr intake Manifold on 370z !! | indyn | Intake/Exhaust | 5 | 06-01-2011 09:06 AM |
481Likes
Hybrid Mode
