First Borla Cat-Back Install on a 370Z

m4a1mustang · 08-30-2009, 11:49 PM

That sounds great. Thanks for the vids!

370z4Steve · 08-31-2009, 09:56 AM

I like it. Nice and deep.

Mr_Z · 08-31-2009, 11:10 AM

Quote:

Originally Posted by mspeasl

What was the Cost and who was your Supplier?

Thanks,

Cost was 2000 USD, including taxes and installation. It was ordered and installed by a performance shop in Montreal Canada.

Mr_Z · 08-31-2009, 11:29 AM

Quote:

Originally Posted by DropTopGal

Is there drone while driving with the Borla?

Compared to stock, how deeper and louder is the sounds?

So, after a few days, here are my comments about the system:

1- There is NO DRONE at all. On the highway, or even at any speed, you won't hear the exhaust unless you press hard on the accelerator.

2- The exhaust is not much louder than stock while driving (not accelerating). But if you push your car a little, it definitely is a bit louder and has a deeper sound. (Check out the clips!)

3- Unfortunately, there is a tiny little rasp at high rev. (That wasn’t the case on my 350Z Borla). The rasp goes away when the exhaust is really hot after 5-10 min of driving. You can’t really hear it from inside the car, but you can hear it in my last vid from inside the garage. I wonder if there is some way of completely removing this.

4- I now have some comments about the clips after a second stop at my performance shop. Even if the clip assemblies fitted very well, looks like I still have a little leak that cause a small (not so noticeable) sound while reving down. You can also hear it in my last vid from inside the garage. We didn't manage to remove it completely so I am thinking about welding the whole thing… Any comments about doing or not doing this from your experiences??

I would really appreciate to hear any suggestions on the two points above (3 and 4) you may have.

One_Quick_Z · 08-31-2009, 01:36 PM

Wow I cant wait to get this!

I had Borla on my 06 350Z and loved it! It sounded great with APS TP and Megan Headers.

DAN

YellowStar · 08-31-2009, 01:59 PM

Love the exhaust.

Any more information on your rear foglight setup? How it was done? parts used etc? I see in the video when you hit the brakes the foglight gets brighter, Does the wiring come for the brighter setting?

Mr_Z · 08-31-2009, 02:56 PM

Quote:

Originally Posted by YellowStar

Love the exhaust.

Any more information on your rear foglight setup? How it was done? parts used etc? I see in the video when you hit the brakes the foglight gets brighter, Does the wiring come for the brighter setting?

Ahhh! I had a feeling I would get questions about this 3rd brake light setup! I believe that this is a little off topic but yes, I redid the whole electrical setup and no, the car does not come wired for this. You need to tap into the tail lights, install a flashing module and manage to install a socket that supports a dual wire bulb. If I have time, I’ll post a DYI.

sloterg · 08-31-2009, 03:11 PM

awesome.. ive always been up and down with borla.. but it sounds great on the 370

LiquidZ · 08-31-2009, 06:27 PM

This exhaust definitely sounds good. Thanks for the videos

DannyGT · 01-26-2010, 04:07 PM

Quote:

Originally Posted by Mr_Z

So, after a few days, here are my comments about the system:

1- There is NO DRONE at all. On the highway, or even at any speed, you won't hear the exhaust unless you press hard on the accelerator.

2- The exhaust is not much louder than stock while driving (not accelerating). But if you push your car a little, it definitely is a bit louder and has a deeper sound. (Check out the clips!)

3- Unfortunately, there is a tiny little rasp at high rev. (That wasn’t the case on my 350Z Borla). The rasp goes away when the exhaust is really hot after 5-10 min of driving. You can’t really hear it from inside the car, but you can hear it in my last vid from inside the garage. I wonder if there is some way of completely removing this.

4- I now have some comments about the clips after a second stop at my performance shop. Even if the clip assemblies fitted very well, looks like I still have a little leak that cause a small (not so noticeable) sound while reving down. You can also hear it in my last vid from inside the garage. We didn't manage to remove it completely so I am thinking about welding the whole thing… Any comments about doing or not doing this from your experiences??

I would really appreciate to hear any suggestions on the two points above (3 and 4) you may have.

Sorry to bring this topic back, but I wanted to mention to you that you do not have a leak. I went thru a similar experience as you and that noise you hear on decel/while revs are dropping is called rasp. Similar to the rasp you hear up top...The only way I know on how to reduce/eliminate it is if you place resonators before the H/X configuration. Thats the point where that resonance hits its peak and it seems to be THEIR that the resonators make the biggest difference.

That and I heard true-dual setups dont get that annoying sound (but I dont think they make as much power either)

So dont bother to weld (or not) because thats the same exact thing I did with my Stillen exhaust and I still had that metallic vibration/rasp sound. Look at the invidia exhaust and the placement of their resonators, thats the spot where it made the loudest sound on my car.

Trust me - I went thru alot...I stayed in the car (on a lift) while they inspected underneath as I rev'd it and I stayed their until they were done welding to only hear the same crap. Its the nature of our car and only gets louder with test pipes. I put GTM resonated test pipes + resonators before my x-pipe and it dramatically reduced the rasp...you hear it quickly ping at 2800rpm and go away almost instantly.

Mr_Z · 01-29-2010, 12:57 PM

Thanks DannyGT for your inputs...

I am not 100% sure that it's some type of rasp because if I recall correctly, we where even able to pin point it to the left side and precisely in what area...we did manage to reduce it by making some adjustment in the junction area as well...

But like you said, I don't think that welding is a good solution. What I plan to do is to lift the car again next spring and remove the clamp. Then wrap a metal tape in the function before putting back the clamp again. If that solves it then I will know that it was a leak. If not, then I will let you know that you where right on!

By now, I am sure that others have Borla on their 370z... Maybe they could tell us if they experience the same thing?

Thanks..

ZPirate · 01-29-2010, 03:56 PM

I have the Borla dual exhaust on my 370Z (I have one on my 350Z too). I experienced some of that raspy sound on decel right after the exhaust was installed.

Now I don't hear it. I don't know if that is becuase I tune it out or that it's gone away. I'll have to listen closer to see if it's still there. I do love to hear the sound of the exhaust though. Not quite as deep of a tone as the Borla on my 350Z, but it still has a nice tone/sound.

zeebra · 01-29-2010, 06:47 PM

Im stuck between this and the Berk CBE. HELP! lol Ive seen one clip on youtube of the Borla on a 370 - I think its Borla's test video and it sounds great. Do you guys get compliments on the exhaust?

ZPirate · 01-29-2010, 10:55 PM

I've had several people compliment the sound. I've also see people turn around to see what just went by as I downshift.

08-30-2009, 11:49 PM	#16 (permalink)
m4a1mustang A True Z Fanatic Join Date: Feb 2009 Location: Northern VA Posts: 55,385 Drives: on two wheels Rep Power: 6962	That sounds great. Thanks for the vids! __________________ - Steve Zs & Coffee - Saturdays at 10AM in Fairfax, VA and Columbia, MD (Click the banner!) LIKE us on Facebook!

08-31-2009, 01:36 PM	#20 (permalink)
One_Quick_Z A True Z Fanatic Join Date: May 2009 Location: Seneca Il Posts: 1,374 Drives: 10 Civic EX Sedan Rep Power: 219	Wow I cant wait to get this! I had Borla on my 06 350Z and loved it! It sounded great with APS TP and Megan Headers. DAN __________________ -My BRZ with exhaust will decimate all if we overnight parts from Japan- 10 Civic EX Sedan- Current Daily

08-31-2009, 06:27 PM	#24 (permalink)
LiquidZ A True Z Fanatic Join Date: Nov 2008 Location: Columbus, OH Posts: 1,940 Drives: Mag. Black 2009 370Z Rep Power: 705	This exhaust definitely sounds good. Thanks for the videos __________________

01-29-2010, 12:57 PM	#26 (permalink)
Mr_Z Base Member Join Date: May 2009 Location: Montreal Posts: 67 Drives: 2009 370Z PG-M6 Rep Power: 16	Thanks DannyGT for your inputs... I am not 100% sure that it's some type of rasp because if I recall correctly, we where even able to pin point it to the left side and precisely in what area...we did manage to reduce it by making some adjustment in the junction area as well... But like you said, I don't think that welding is a good solution. What I plan to do is to lift the car again next spring and remove the clamp. Then wrap a metal tape in the function before putting back the clamp again. If that solves it then I will know that it was a leak. If not, then I will let you know that you where right on! By now, I am sure that others have Borla on their 370z... Maybe they could tell us if they experience the same thing? Thanks.. __________________ 2005 350Z 35th - SilverStone 2009 370Z Touring/Sport - Platinum Grey

01-29-2010, 03:56 PM	#27 (permalink)
ZPirate Track Member Join Date: Dec 2008 Location: Greenville, NC Posts: 792 Drives: 09' 370Z & 03' 350Z Rep Power: 18	I have the Borla dual exhaust on my 370Z (I have one on my 350Z too). I experienced some of that raspy sound on decel right after the exhaust was installed. Now I don't hear it. I don't know if that is becuase I tune it out or that it's gone away. I'll have to listen closer to see if it's still there. I do love to hear the sound of the exhaust though. Not quite as deep of a tone as the Borla on my 350Z, but it still has a nice tone/sound. 370z2013 likes this. __________________ 2003 Daytona Blue 350Z Touring/Nismo 2009 Platinum Graphite 370Z Touring/Sport (Sold) 2009 BMW 135i/Dinan Stage 2 software upgrade/M3 suspension piecies/Koni Sports/ETS FMIC/Alufelgen SF-71 wheels Last edited by ZPirate; 01-29-2010 at 10:54 PM.

08-31-2009, 09:56 AM	#17 (permalink)
370z4Steve Base Member Join Date: Jan 2009 Location: west Posts: 231 Drives: 370z Rep Power: 672	I like it. Nice and deep.

08-31-2009, 01:59 PM	#21 (permalink)
YellowStar Base Member Join Date: Jul 2009 Location: La Mirada, ca Posts: 40 Drives: 2011 370z Rep Power: 16	Love the exhaust. Any more information on your rear foglight setup? How it was done? parts used etc? I see in the video when you hit the brakes the foglight gets brighter, Does the wiring come for the brighter setting?

01-29-2010, 06:47 PM	#28 (permalink)
zeebra Base Member Join Date: Feb 2009 Location: Florida - Boca Raton Posts: 60 Drives: 09 Mag Black 370z Rep Power: 16	Im stuck between this and the Berk CBE. HELP! lol Ive seen one clip on youtube of the Borla on a 370 - I think its Borla's test video and it sounds great. Do you guys get compliments on the exhaust? __________________ 2009 MB Sport Package 370z For Sale 31k miles $24,000

01-29-2010, 10:55 PM	#29 (permalink)
ZPirate Track Member Join Date: Dec 2008 Location: Greenville, NC Posts: 792 Drives: 09' 370Z & 03' 350Z Rep Power: 18	I've had several people compliment the sound. I've also see people turn around to see what just went by as I downshift. 370z2013 likes this. __________________ 2003 Daytona Blue 350Z Touring/Nismo 2009 Platinum Graphite 370Z Touring/Sport (Sold) 2009 BMW 135i/Dinan Stage 2 software upgrade/M3 suspension piecies/Koni Sports/ETS FMIC/Alufelgen SF-71 wheels

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
First Aftermarket Nav install in a 370Z 12.16.08	AK370Z	Audio & Video	48	10-14-2012 06:59 PM
Borla 370Z Exhaust Ready	SoCal 370Z	Intake/Exhaust	26	05-17-2011 11:40 PM
Borla Cat Back and Nissan Issues?	DooDooBrown	Intake/Exhaust	2	08-25-2009 07:27 PM
370Z Borla Exhaust Development	AK370Z	Intake/Exhaust	43	07-06-2009 08:41 PM
Mine's Cat-Back Exhaust for the 370Z Z34 12/18/08	Slidefox	Intake/Exhaust	40	03-03-2009 05:04 AM