06-02-2011, 05:32 PM
|
#11 (permalink)
|
|
Track Member
Join Date: Jul 2010
Location: Sandy Hook, CT
Posts: 972
Drives: Nissan 370z Nismo
Rep Power: 16
|
Quote:
Originally Posted by wstar
Be careful it's not too close. Mine sit about 0.3 - 0.4cm from the bumper (as measured with a caliper, one is a little lower than the other), and over time they've very slightly melted/scorched the underside surface of the bumper in a tiny spot. You can't see it from the rear so I could care less, just FYI. The only reason mine are so close is because I had some tip clearance problems due to (we believe) the output location of the Stillen short-tube headers that are currently on the car. I used washers to space off the rear hanger bolts to give even that much clearance.
Honestly from the pic the clearance and side-to-side difference looks pretty normal to me. Maybe if it were up closer or if I could move side to side and stare at the angles in realtime, I'd notice, but I donno.
|
Yea its hard to tell by the pic. at this point i think ive just been starring at it for too long and my eyes are playing tricks on me haha.
|
|
|
Similar Threads
3Likes
Threaded Mode
