aem eti
 

Does anyone have the aem eti intake and opinions please?

My opinion is post this in the "intake" section... my second opinion is search and find out.

Im new to this so I didn't know where i was posting.

I came across this and I just bought/installed this intake so I'll chime in. First of all I don't have any pre or post install dyno measurements. Install was a little lengthy; took me a couple hours and I wasn't able to finish everything due to my 25-row oil cooler. I wasn't able to re-install the washer fluid bottle because my oil cooler was in the way.

It sounds about the same. It feels like it pulls a little more. Car is a little more fun to drive. Don't expect significant gains. According to my "Ultra Guage", intake air temps aren't bad when the car is moving and are just a few degrees higher than OEM. I purchased mainly for the cosmetic appeal and adding something different to the engine bay. Having the increased airflow is nice. Would I buy it again? Probably not. I'd save money towards forced induction. I'll post pics later when I take some.

Good Logic
 

I have to agree with you, I'm going to buy the Typoon setup because it should be an easy install, the bright blue intake hoses look good but you still have to run the stock airbox

With intakes and pulleys, I gaind 17whp on top of my existing mods. Mods were LTH's, HFC, and exhaust. The gains are mostly up top in the power band, but can be seen in the mid range as well. I have no complaints or second thoughts.