and this:driving:

Where you on jackstands in the last vid?

Hey Tony, I am getting rattling from the difuser. Does it look like the exhaust fitment is right? I have the EVO-R difuser.


https://lh3.googleusercontent.com/-D...1108130636.jpg

https://lh3.googleusercontent.com/-0...1108130637.jpg


https://lh5.googleusercontent.com/-J...108130637a.jpg

https://lh6.googleusercontent.com/-J...108130637b.jpg


https://lh4.googleusercontent.com/-q...1108130638.jpg

I would say it is too close. Needs a little bit of a gap. You will need to add some washers to each of the screws on the hanging bracket.

^ Thanks, my mechanic was thinking the same. Just checking with the guru - Tony to ensure we do not have to disassemble the entire exhaust system and start over. We did follow the instructions.

You need to space the tips down to create clearance between the top of them and the diffuser. It should not take much. There is no need to loosen the exhaust system to do this.

Thanks, Tony

Thanks Tony :tiphat:

no no it wAS on a dyno. because of the body kit with no spacers, they had to slightly lift the one side so it wouldn't rub:tiphat:

FYI everyone tracking ypor systems. #835 shipped today:happydance:

I will install it Tuesday night when it arrives.

#836 buddy. :tup: Mine shipped too.

Thanks for the updates.

How do you know what number your system is down the list?

On your invoice under PO I put your build number. Right side of the invoice about 1/3 of the way down.

Thanks, Tony

#884!
Got it, wewt!

This is a little video of a lap out at Miller Motor Sports park today. Raining with periods of snow falling this morning with a few breaks in the weather.

The event is run as a one lap time attack with two groups alternating every 30 min. We had 2 morning practice sessions then after lunch 2 afternoon sessions to determine the winners for each group. It was allot of fun but, you really had to tip toe around to keep from sliding out. The run on the video was of the driest of the day and the spin at the end was from my first practice session.

I just installed the Fast Intentions HFC's and a 12" resonated TDX with the CF cans. I can honestly say that I had the best sounding exhaust today. While I'm sure others are good as well I have this one so it's the best :tup: Thought this would give you guys yet another video to listen to while you wait for your systems.:tiphat: