Has anyone installed Stillen G3s from a 350Z HR?
 

Reason why I ask...I bought my Stillen G3s used from a 350Z HR owner. I installed them on my car without a problem. I sold them to a forum member on here after I did the single turbo on my car. I was unaware that there was any difference between the G3s for a 350Z HR vs a 370Z...therefore I didn't know I had the 350Z Stillen G3s. The guy I sold them to is having a problem installing them and I'm trying to help him figure out how to install them.

If anyone has installed them, do you have pictures of them installed? Specifically with the front bumper off?

maybe descsribe the problem and we can help out. otherwise i do not know of anyone who has done it.

Oops. I left that part out. The middle piping looks to be 2-3 inches shorter on the 350Z HR kit compared to the 370Z kit according to the pictures the buyer sent me. Like I said, I was unaware I had a 350Z specific kit and the kit fit fine on my car. I'm just trying to help the buyer figure out why he's having a problem...and pictures would be very helpful.

You can use the coupler space between the pipe and throttle body to make up for 2-3"s. Just move the pipe closer to the edge and clamp tight.

yeah just slide the piping close tot he edges of the silicone coupler.

Didn't see this. I bought 6 inch couplers to connect the two pipes instead of the 3 inch couplers from stillen. Seem to be working fine.

Good! I'm glad you finally got them installed. I wish I had kept my car NA with bolt ons...