Stillen HFC vs. BERK HFC

NIZMOZ · 04-13-2009, 03:42 PM

Quote:

Originally Posted by travisjb

Ok... are you saying that based on experience with a 350z or this car ?

Josh, this would be a good place for you to step in and comment

350Z with the HR. The HR is so similar to your 370z VHR that it will happen. Reason why Berk said it too that it needs the non-foulers.

NIZMOZ · 04-13-2009, 03:44 PM

Quote:

Originally Posted by wstar

FWIW, I've had zero CELs on my Berk HFCs, and they've been on the car now for about 1,400 miles. Those miles include a wide variety of driving styles as well as several OBD-II driving cycles (my little OBD-II unit shows me driving cycle progress). Obviously in the pictures we have, the Stillen unit doesn't have an extended tube for the O2 like the Berk one does, but I don't know what that really means in terms of results until we get some people independently testing them.

Just give it time. Many didn't have the light show for thousands of miles. Mine showed after 3000 miles. Dunno what changed but it did.

NIZMOZ · 04-13-2009, 03:46 PM

Quote:

Originally Posted by semtex

In all this discussion about CELs and extended tubes, etc., I think we've glossed over something else that's kinda significant. Stillen claims less of a gain on their HFCs than Berk. Although I must say, their web page for the HFCs is a tad confusing right now, because they claim only +9hp and +8ft/lbs tq. Yet, when you open up their dyno chart (for a G37), it shows +16hp and +13ft/lbs tq. In any case, they're claiming less gain than Berk either way you look at it.

It is possible they are using a less flowing cats on theirs compared to Berk, so they may clean better but also flow slightly better. Berks are proven and flow great. If someone get's these cats, please take a picture inside of the cat so we can see how they are made through one of the pipe openings.

wstar · 04-13-2009, 04:22 PM

Quote:

Originally Posted by NIZMOZ

Just give it time. Many didn't have the light show for thousands of miles. Mine showed after 3000 miles. Dunno what changed but it did.

What was the actual cause of your CEL that showed up 3k miles after the install though? Lots of things can cause P0420/P0430. Are you saying that you're really putting out too much emissions to the sensor, but it took 3k miles for the ECU to notice? I think that's unlikely. The 1,400 I've got on this setup now are more than enough for an OBD-II drive cycles to have picked up any real problem. What happened during those 3k miles? Other change to the car? Some kind of buildup in the cats or on the sensor itself? Heat changes?

NIZMOZ · 04-13-2009, 04:25 PM

The cats caused it. Exactly as you said. As many have noticed on the forum, it took their cars 3-4k of miles to have a light come on. Some came on right away, but most took a few thousand miles.

Nothing changed on my car during that time. Nothing.

spiderman · 04-13-2009, 05:12 PM

My car should be delivered in about 2 weeks. I was thinking of putting on the Stillen Catback along with the Stillen G3 CAI's. I'm looking more for sound versus a bump in performance (although that's great too). Is adding the Berk HFC's really needed or will the Catback itself do a nice job in getting better sound? thanks!

semtex · 04-13-2009, 05:51 PM

Quote:

Originally Posted by spiderman

My car should be delivered in about 2 weeks. I was thinking of putting on the Stillen Catback along with the Stillen G3 CAI's. I'm looking more for sound versus a bump in performance (although that's great too). Is adding the Berk HFC's really needed or will the Catback itself do a nice job in getting better sound? thanks!

The catback itself will give you a much deeper sound.

RCZ · 04-13-2009, 07:34 PM

Gahhh I want the Stillen pipes already!

dainedazz · 04-14-2009, 07:59 AM

hmmm CEL's with HFC's? tsk tsk. i hate it when i see that light. i had that on my old b13. hmm did anyone have CEL's on their Stillen Cat back alone? or even with the g3's? i really would like to know cuz i'm really interested in getting the Stillen exhaust system with the g3 intakes. i was wondering if they'll throw CELs. looking forward to answers.

semtex · 04-14-2009, 08:06 AM

Quote:

Originally Posted by dainedazz

hmmm CEL's with HFC's? tsk tsk. i hate it when i see that light. i had that on my old b13. hmm did anyone have CEL's on their Stillen Cat back alone? or even with the g3's? i really would like to know cuz i'm really interested in getting the Stillen exhaust system with the g3 intakes. i was wondering if they'll throw CELs. looking forward to answers.

I haven't had a single CEL, and I have all three components installed.

NIZMOZ · 04-14-2009, 08:52 AM

^^ Like I said, give it more time. We all thought the same at first.

semtex · 04-14-2009, 09:10 AM

^^ I'm just answering the guy's question, not taking a position as to whether or not it'll ever happen. And quite frankly, I don't care if it does. If it throws a CEL, then I'll fix it. I just don't consider it that big a deal. If you're into modding, it just comes with the territory as far as I'm concerned. I expect problems, and when I don't experience them I consider it a bonus that exceeds my expectations. IMHO, anyone who expects everything to be smooth sailing just isn't experienced at modding.

Musashi · 04-14-2009, 09:15 AM

Quote:

Originally Posted by dainedazz

hmmm CEL's with HFC's? tsk tsk. i hate it when i see that light. i had that on my old b13. hmm did anyone have CEL's on their Stillen Cat back alone? or even with the g3's? i really would like to know cuz i'm really interested in getting the Stillen exhaust system with the g3 intakes. i was wondering if they'll throw CELs. looking forward to answers.

I have the Stillen cat back and gen 3 air intake. NO CELS.

Kyle@STILLEN · 04-14-2009, 01:20 PM

Hey Guys,

Sorry that we haven't jumped in here yet. Josh and I hadn't seen this thread until it was brought to my attention.

It's pretty much a gaurantee that the hi-flow cats will set off check engine lights. We are currently working on a way to defeat that though and hope to have that solution soon. Our engineers are testing two different ways to fix the CEL issue. We would like to stay away from tricking the ECU if possible.

In regards to the advertised horsepower output. You are correct, we have a typo on the website and we will correct that ASAP. The dyno for the G37 is the one we should be using for the 370Z but our literature is from the 350Z.

axio · 04-14-2009, 04:40 PM

Quote:

Originally Posted by semtex

^^ I'm just answering the guy's question, not taking a position as to whether or not it'll ever happen. And quite frankly, I don't care if it does. If it throws a CEL, then I'll fix it. I just don't consider it that big a deal. If you're into modding, it just comes with the territory as far as I'm concerned. I expect problems, and when I don't experience them I consider it a bonus that exceeds my expectations. IMHO, anyone who expects everything to be smooth sailing just isn't experienced at modding.

How exactly do you intend to fix it? I ordered the Berk cats, and like you, i'm not too concerned about a CEL. But if it shows up, is the fix something as simple as removing the cat, and then inspecting it and cleaning it out?

Forgive me if this is incorrect, but could the CEL be showing up on these Berk cats because of carbon build-up in that O2 sensor extender tube? could it be something as simple as removing the O2 sensor and then cleaning any carbon build-up? Again, I have no idea, just throwing out some possibilities on what could be causing it.

04-13-2009, 04:25 PM	#50 (permalink)
NIZMOZ Track Member Join Date: Nov 2008 Location: San Antonio, TX Posts: 634 Drives: 07 NISMO 350Z SA M6 Rep Power: 491	The cats caused it. Exactly as you said. As many have noticed on the forum, it took their cars 3-4k of miles to have a light come on. Some came on right away, but most took a few thousand miles. Nothing changed on my car during that time. Nothing. __________________ SOLD: 2007 NISMO 350Z #0044 Silver Alloy New DD: 2010 Titan Pro4X CC

04-13-2009, 05:12 PM	#51 (permalink)
spiderman Base Member Join Date: Feb 2009 Location: Ellicott City, MD Posts: 57 Drives: PG Touring/Sport/6M Rep Power: 268	My car should be delivered in about 2 weeks. I was thinking of putting on the Stillen Catback along with the Stillen G3 CAI's. I'm looking more for sound versus a bump in performance (although that's great too). Is adding the Berk HFC's really needed or will the Catback itself do a nice job in getting better sound? thanks! __________________ *grateful to be alive ... grateful to drive!*

04-14-2009, 08:52 AM	#56 (permalink)
NIZMOZ Track Member Join Date: Nov 2008 Location: San Antonio, TX Posts: 634 Drives: 07 NISMO 350Z SA M6 Rep Power: 491	^^ Like I said, give it more time. We all thought the same at first. __________________ SOLD: 2007 NISMO 350Z #0044 Silver Alloy New DD: 2010 Titan Pro4X CC

04-14-2009, 09:10 AM	#57 (permalink)
semtex A True Z Fanatic Join Date: Jan 2009 Location: Behind enemy lines Age: 54 Posts: 5,995 Drives: People to drink Rep Power: 32	^^ I'm just answering the guy's question, not taking a position as to whether or not it'll ever happen. And quite frankly, I don't care if it does. If it throws a CEL, then I'll fix it. I just don't consider it that big a deal. If you're into modding, it just comes with the territory as far as I'm concerned. I expect problems, and when I don't experience them I consider it a bonus that exceeds my expectations. IMHO, anyone who expects everything to be smooth sailing just isn't experienced at modding. __________________ "There are no small accidents on this circuit." -- Ayrton Senna 316.8whp & 248 ft/lbs (Dyno Dynamics) \| 319whp & 256 ft/lbs (DynoJet) (04/23/10) Stillen G3 CAI, CBE, Pulley / F.I. LTH / GTSpec Ladder Brace / Setrab Oil Cooler / UpRev-tuned by Forged Perf. Last edited by semtex; 04-14-2009 at 09:14 AM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Berk Technology HFC Install	M.Bonanni	DIY Section (Do-It-Yourself)	203	08-03-2018 06:12 AM
Stillen Exhaust with Berk HFCs	semtex	Intake/Exhaust	127	12-01-2009 03:53 PM
Stillen Headers + Berk HFCs self-install report	wstar	Intake/Exhaust	84	04-14-2009 01:09 PM
Redline Time Attack Results are in! DDM 370Z, BERK S2000 & BERK BMW 135i on track!	BerkTech	Track / Autocross / Drifting / Dragstrip	8	04-02-2009 12:37 PM

04-13-2009, 07:34 PM	#53 (permalink)
RCZ A True Z Fanatic Join Date: Nov 2008 Location: Miami Posts: 6,403 Drives: '09 370Z Rep Power: 1118	Gahhh I want the Stillen pipes already!

04-14-2009, 07:59 AM	#54 (permalink)
dainedazz A True Z Fanatic Join Date: Jan 2009 Location: NY, NJ, Philippines Posts: 1,325 Drives: 09' SR 6MT Z34 Rep Power: 293	hmmm CEL's with HFC's? tsk tsk. i hate it when i see that light. i had that on my old b13. hmm did anyone have CEL's on their Stillen Cat back alone? or even with the g3's? i really would like to know cuz i'm really interested in getting the Stillen exhaust system with the g3 intakes. i was wondering if they'll throw CELs. looking forward to answers.

04-14-2009, 01:20 PM	#59 (permalink)
Kyle@STILLEN The370Z.com Sponsor Join Date: Dec 2008 Location: Newport Beach Posts: 626 Drives: Toyota Tundra Rep Power: 306	Hey Guys, Sorry that we haven't jumped in here yet. Josh and I hadn't seen this thread until it was brought to my attention. It's pretty much a gaurantee that the hi-flow cats will set off check engine lights. We are currently working on a way to defeat that though and hope to have that solution soon. Our engineers are testing two different ways to fix the CEL issue. We would like to stay away from tricking the ECU if possible. In regards to the advertised horsepower output. You are correct, we have a typo on the website and we will correct that ASAP. The dyno for the G37 is the one we should be using for the 370Z but our literature is from the 350Z.