This results are pre chip tune right?
|
|
LinkBack | Thread Tools | Display Modes |
10-11-2012, 03:39 PM | #32 (permalink) |
Base Member
Join Date: Oct 2011
Location: Dallas, TX
Posts: 143
Drives: An Evil Monkey
Rep Power: 14 |
I have this same set-up with the G3s.... and love it! Docile when cruising below 3.5k, then really humms when you hit it.
__________________
Chris '70 Datsun 2000 Roadster '09 370z- Invidia, Stillen G3, ZEnclosure |
10-11-2012, 08:36 PM | #33 (permalink) |
Base Member
Join Date: Sep 2010
Location: Suffolk cty New York
Posts: 159
Drives: 10 BC 370ZR S/T M6
Rep Power: 15 |
These numbers are pre uprev tune. Now at 337whp after the tune.
__________________
78 Z1R, '08 ZX10R, 2010 BC Roadster S/T, 6M, Stillen G2 CAI, Invidia CBE, Berk test pipes, Painted headlights (180˚Custom), JDM rear fog, B&M short shifter, Stillen front plate mount, stubby antenna, setrab oil cooler, uprev. 337rwhp 254ft/lb corrected! |
10-12-2012, 07:36 AM | #34 (permalink) |
Base Member
Join Date: Apr 2011
Location: Columbus, GA
Posts: 212
Drives: 2011 370z 7at GM
Rep Power: 14 |
And this is with the gen 2? Everyone keeps saying just get the gen 3, but this kinda proves that gen2 does make good power.
__________________
Z1 Test Pipes, AAM S-Line Midpipe, Nismo Axleback, Takeda CAI, JDM fog light, Avant Garde M310 matte black, Tein springs, uprev 310whp-SOLD! |
10-13-2012, 11:08 AM | #35 (permalink) | |
Base Member
Join Date: Sep 2010
Location: Suffolk cty New York
Posts: 159
Drives: 10 BC 370ZR S/T M6
Rep Power: 15 |
Quote:
It is with the gen 2. A longer intake tract will yield greater mid and low range power while a shorter tract will yield greater high range power. This is a general statement assuming all other factors are equal. The gen 2 might have a slightly increased intake charge temp at low speeds but once the car is moving the shrouds keep warm under hood air away from the intakes. Also, there is a substantial difference in maintanence as the short (gen2) tube intake filters access does not require removal of the bumper. In reality this maintenance ease is the primary reason I went with the gen2. I really wouldn't expect a big difference isn actual rwhp between the two (gen2-gen3) with stock motor internals. Also, my dynos are a little deceiving. I installed the CBE first so that yielded the greatest performance gains. If I had installed the CAI first the high gains would have been with that. The real lesson here is that to really reduce parasitic pumping loss and get the best efficiency (resulting in maximum performance gains) one must improve flow at both intake and exhaust allowing the motor to breathe easier. I have final dyno info, will post soon. Biggest improvement is in mid range. Most noticeable, substantial drivability improvement.
__________________
78 Z1R, '08 ZX10R, 2010 BC Roadster S/T, 6M, Stillen G2 CAI, Invidia CBE, Berk test pipes, Painted headlights (180˚Custom), JDM rear fog, B&M short shifter, Stillen front plate mount, stubby antenna, setrab oil cooler, uprev. 337rwhp 254ft/lb corrected! |
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
invidia hfc? | 370z_2910 | Intake/Exhaust | 1 | 08-19-2010 09:00 AM |
Give up on Berk? Go with Invidia? | Dembflyr | Intake/Exhaust | 40 | 08-06-2010 06:37 AM |
Invidia Genini CB exhaust | Big J | Parts for sale (Private Classifieds) | 3 | 07-20-2010 01:51 PM |
INVIDIA Test Pipes | Kastley85891 | Parts for sale (Private Classifieds) | 20 | 07-13-2010 12:01 PM |
Invidia Gimini | The BlueMax | Intake/Exhaust | 65 | 04-28-2010 02:58 AM |