Stillen Or Fast Intentions ?

Holliday

I like the "mufflers" painted black. It looks really clean. Nice Job 6spd!

__________________

6spd

thank you sir! even though i like being the only person with this done, i would like to see i more often, it looks better imo.

__________________
-Jay- jonathanjamesphotographer.com

Push370zzz

I understand many people had this problem, but here is how mine when on on the first try. Yes, they stuck out a bit when you fist hang it which is why I pushed the exhaust onto the hangars and slip fittings until it was all in place. If you put your HFCs on the wrong side, you would probably have some fitment issues too

Attached Images

	2010-08-29_16-15-07_416[1].jpg (487.4 KB, 47 views)
	2010-08-29_16-15-14_498[1].jpg (532.3 KB, 46 views)
	2010-08-29_16-15-21_474[1].jpg (388.6 KB, 31 views)
	2010-08-29_16-15-28_810[1].jpg (443.3 KB, 28 views)

__________________
Range Rover Sport Supercharged
Nissan 370z Touring + Sport

Elia Cid

"exhaust that has ridiculously large tips that stick past the bumper, get Stillen." A little bit over the top don’t you think!

Stillen are not quieter they just sound nicer and richer, minus drone IMO.

Will provide sound clip once mines are installed! See link Best Exhaust?

Alex

__________________

G Fo12ce

Both seem to be popular. You should consider the HKS too. I like mine and AK did a nice write up on his here:
HKS Exhaust

__________________
Nismo Suspension: New Owners Check Here!

BOLIO 671

But since Berk was not included, I definately would go with FI over the Stillen...just for the same reasons that everyone else has already mentioned...

__________________
2013 Nismo Z34 / FI TT #091 / IG: @lilzilla_z34

Mora

I would go with FI because:

-the "customer service" is fantastic.
-the system is lighter than Stillen's solution.
-You can choose how much it will be loud.

Elia Cid

My money's on Stillen CBE ,

New Stillen CBE should arrive on Wednesday of next week the 1st, FedEx tracking, thanks Max@Stillen.

CBE are being installed by my Nissan dealership to go with my newly installed Stillen G3 intakes they also installed , let me say they did a great install.

I want to hear Stillen CBE for a while before deciding to install HFC or not , if i do I'll most likely go with Berk's HFC.

I'll try to post a sound video then.

Stay tuned,

Alex

__________________

Holliday

From a non-bias opinion, I think the tips stick out to far IMO. GTM makes a nice exhaust but the tips don't do it for me. Stillen is still a good exhaust and you can always have the tips aligned or changed out for that matter. After doing all my research on CBE Stillen was deemed heavy, expensive, and ugly tips" in my book. I am not trying to rain on anybodies parade so take all this as someones opinion. Good luck with your install Alex.

__________________

MOHA

Thanks you guys. i'm ordering the FI. but what is the difference between Non Resonated, 12 Res and 18 Res ?

Jamaica

Good choice. Non resnonated is the loudest. 12 res is in the middle and 18 res is a little bit louder.

Push370zzz

You can adjust them from being about an inch before the cutouts to four inches or so past them...I don't get why everybody is acting like this is a drawback when it is just a poor installation job!! Not liking the tips is one thing and subjective so whatever, but they fit perfect with about a minute or two of alignment

__________________
Range Rover Sport Supercharged
Nissan 370z Touring + Sport

WGJB

Greetings all.

I'm fairly new to this forum and this is my first reply. I installed a Stillen Cat-back and Berk HFCs. Stillen because it is not lower than stock and Berk because they are OBDII compliant. The sound is not quiet, for me, and I would not want it any louder. Fitment on the Stillen is poor, at best. The left tip was perfectly centered and the right tip was inboard one half inch. Also, the tips are not equal fore and aft. The mechanic who installed the system said there is no adjustment, so I took it to a custom exhaust specialist of 34 years. He was able to heat and tweek the hangers to get the tips equally misaligned. Fore and aft, no. The other option was to cut and reweld the tips, which I didn't do yet.

Stillen's answer was "sorry, you mounted and ran the exhuast, we will not take it back." So basically their return policy is, if you don't like the way it looks in the box, send it back. Thanks, Max and Chuck at Stillen. Pesonally I will no longer support Stillen for their lack of support regarding their product.

I am also sorry my first reply is negative feedback. I've been following this forum since March of this year and purchased my 2010 370Z in May. I do like this forum and love my Z.

Regards,

Elia Cid

Everyone's entitled to their own research and opinion, that being said , you could have just said Stillen just don’t do it for you, for whatever reasons in a better way IMO , but when you start using words like “ridiculously “ to describe those reason that a different issue!

“If you want a heavier, quieter exhaust that has ridiculously large tips that stick past the bumper, get Stillen.” Sorry in my book that’s over the top!

And no you didn’t rain on my parade; I’m very much looking forward to having the Stillen exhaust installed.

The exhaust will be here tomorrow, and installed the next day.

As I said I’ll try to post a video sound clip.

Alex

__________________

redroadster10

i have the fi 18" on my roadster and love the exhaust so moha your making a great choice by going fi over stillen