Low bite point after CSC replaced.

ichris · 05-10-2019, 08:09 AM

So I had the infamous whistle noise. Nissan changed the CSC, bearing, and replace the fluid. I immediately notice the bite point is much lower. Is that normal? Should I bring it back or bring it to another service center cause I did drive it back and tech said it was normal.

Sent from my iPhone using Tapatalk

ZontheRocks · 05-10-2019, 08:40 AM

How did he prove to you it was normal? Is there a guide in the FSM he can show you?

Stock for stock replacement should feel the same, not different.

Also, if the master cylinder was not also replaced, the chances of the CSC going out are high.

ichris · 05-10-2019, 09:58 AM

Quote:

Originally Posted by ZontheRocks

How did he prove to you it was normal? Is there a guide in the FSM he can show you?

Stock for stock replacement should feel the same, not different.

Also, if the master cylinder was not also replaced, the chances of the CSC going out are high.

The tech drove it around after I got it back. I just got use to driving it with high bite point. Now its about a little over 1/3 up from the floor. The CSC never went bad. It had a whistle noise. They just replace CSC, Throwout bearing, and fluid. I still have 6 yr extended warranty. When It get close to the end.. Going Zspeed.

Spooler · 05-10-2019, 09:09 PM

Sounds like it has air in the system.

05-10-2019, 08:09 AM	#1 (permalink)
ichris Base Member Join Date: Mar 2019 Location: New Jersey Posts: 26 Drives: 16 Nissan 370z PS M6 Rep Power: 6	Low bite point after CSC replaced. So I had the infamous whistle noise. Nissan changed the CSC, bearing, and replace the fluid. I immediately notice the bite point is much lower. Is that normal? Should I bring it back or bring it to another service center cause I did drive it back and tech said it was normal. Sent from my iPhone using Tapatalk

05-10-2019, 08:40 AM	#2 (permalink)
ZontheRocks Track Member Join Date: Mar 2017 Location: Central Florida Posts: 959 Drives: 2016 Nissan PW 370Z Rep Power: 34535	How did he prove to you it was normal? Is there a guide in the FSM he can show you? Stock for stock replacement should feel the same, not different. Also, if the master cylinder was not also replaced, the chances of the CSC going out are high. Last edited by ZontheRocks; 05-10-2019 at 09:32 AM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GT Spec Chassis Braces [6-Point Front & 2-Point Rear] Installed on Nismo Review	jcosta79	Brakes & Suspension	33	01-23-2018 01:30 AM
[WTB] WTB: GTSpec 4-point ladder / 2-point rear brace	sid67jp	Parts for sale (Private Classifieds)	1	03-01-2016 11:39 PM
Used 2010 370z for sale locally should I bite?	Auntiecoco	Nissan 370Z Pricing / Ordering Discussions	16	03-15-2015 04:48 PM
CSC needs to be replaced again anything else i should do?	luigi90210	Engine & Drivetrain	10	02-08-2014 06:17 PM
Replaced tires on SUV and...	PapoZalsa	The Lounge (Off Topic)	3	12-22-2009 11:16 AM

05-10-2019, 09:09 PM	#4 (permalink)
Spooler A True Z Fanatic Join Date: Jun 2014 Location: Ga Posts: 13,834 Drives: 2013 Nismo 370z Rep Power: 2684392	Sounds like it has air in the system.