|
So this past weekend I installed a Takeda long tube intake, Berk Tesp Pipes (non res) and JWT flywheel. So anytime I get around 2500-3000k RPMS during acceleration and decel,
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
04-21-2015, 11:32 AM
|
#1 (permalink) |
|
Base Member
Join Date: Dec 2014
Location: Jacksonville
Posts: 101
Drives: 09 Nissan 370Z
Rep Power: 11  |
bad noise after Berk TP install
So this past weekend I installed a Takeda long tube intake, Berk Tesp Pipes (non res) and JWT flywheel.
So anytime I get around 2500-3000k RPMS during acceleration and decel, I get a bad Rattle noise, Then it smooths out and and sounds as it should. So I can tell the difference between the hiss on decel, the normal rasp of non res pipe during accel, and the jitter from the flywheel on low RPM, but this rattle sound I cannot figure out. Any one experience anything similar? I'll try to get a video later. Last edited by Etzio; 05-15-2015 at 12:25 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Engine Noise post-Oil Cooler Install | spearfish25 | Engine & Drivetrain | 65 | 04-09-2015 12:59 PM |
| Berk HFC/CBE Combo - Rattling Noise | tiger123 | Intake/Exhaust | 5 | 06-24-2014 04:18 PM |
| Just install exhaust but noise | richiivu | Intake/Exhaust | 8 | 02-19-2013 05:59 PM |
| Berk HFC & CBE Install | chill1221 | Intake/Exhaust | 13 | 01-02-2012 10:30 PM |
| Berk HFC Install Went OK | teejnut | Intake/Exhaust | 8 | 01-12-2010 06:07 AM |
7Likes
Threaded Mode
