So just ordered my Stillen SC

mikey1600

Day 3;

thought I'd throw up a few pictures as well (they have been added to my album), got a fair bit done today. Came up with a really good solution for everyone upgrading to the frozenboost heat exchanger, this involves the lower part of the crash bar frame (not the main beam) and using the arms as brackets so the heat exchanger sits back far enough so you don't have to cut up the front bar + don't have to cut up the crash bar itself. It's a combination between Vlad and Ivo's installs. Measured the heat exchanger to need to sit around 20-25mm behind being flush with the crash beam. You'll still need to remove the standard drain plug and find something to block the hole, I'll be trying to find a Hex key bolt like the one already on the unit in another place, and also cut out a whole in the plastic which screws to the front bar so I can drain the fluid when needed, just like you would with the engine's radiator. I'll label the pictures as Frozenboost so you get the idea, any questions just ask.

managed to mount the blower along with the water pump/water reservoir/overflow bottle/plumbing for it and put the new belt on, test fit the intakes to make sure they don't interfere with the heat exchanger positioning. I did have to move the horns, on the Aus models we have a High and Low horn, one is on either side of the front, I've had to move the one from the right (looking at the front of the car) to the left hand side, just used the same bracket as the existing one and put them both onto it. Also tidied up some of the cabling etc in the engine bay, it was starting to get all over the place, so removed some mounts, moved some cables under/over things and redone the mounts.

Tomorrow will be heading out first of all to get the water plugs/hex key for drain of the heat exchanger and getting distilled water (already have the MoCool) along with new genuine nissan coolant for engine (as I had to drain it even after being told multiple times would not!)

up to page 22 of 37 for tomorrows start after finishing off the cooler stuff, there's not many parts left over now, mainly some wiring to do and some more plumbing, STILL waiting on my tune file.... will be ringing vivid again tonight to try get it, also contacted my tuner and they are seeing if they have anything available from previous stillen installs.