S&R Performance single turbo kit?

TopgunZ

Im not saying this is a poor kit design. I wouldn't have bought it had I felt that way. Im just saying that it plays a role in the setup.

I also had a turbo blanket on my turbine, Ive never seen one on the compressor though which is only an inch or so away from the intake pipe.

I almost cut my throttle body off and welded it to the other side of the intake plenum so that the intake pipe wouldn't sit over the turbo.

I removed my drivers side wheel well guard to get more air to pass by the turbo and get it out of the bay. This also allowed you to hear the turbo spool more which is always a bonus.

Where BP places theirs just makes a whole lot of sense to me. They also state 650+ on that setup. However, May would be the earliest for that route now.

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

TopgunZ

Funny thing about this is that after I put the turbo blanket on I could literally hear left over oil boiling in the turbo. I have never investigated this but it didn't sound good to me knowing that oil is going to recirculate back into the system. It caused paranoia and I changed my oil every 1500 miles..lol..

PS. Never heard that before the blanket was on.

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

Boosted Performance

Location aside, the big reason for the high HP rating is the option of a 67mm (935HP as rated by manufacturer) turbo with a large T4 turbine.

It is simply crucial to have a large T4 turbine on these engines, and the test result I did last year have confirmed this. IMO anything smaller than a true T4with large A/R ratio, will generate excessive exhaust back pressure (exhaust pressure between heads and turbine inlet), greatly reducing efficiency and high HP potential. The turbine becomes a huge choke point if not sized properly, and the power will simply dive. Any time you see a dyno graph where TQ is lower than max HP (or if the two are even getting close), it is a good indicator that the turbine has reached its maximum flow limit.

Remember, all that air the compressor pushes out is mixed with fuel and ignited....all this has to go through the turbine housing.

__________________
750WHP starting @ $7,500 to the door
FOR DETAILS VISIT: http://www.the370z.com/members/boosted-performance.html
FB: https://www.facebook.com/Boosted-Per...6303179791462/
IG @boostedperformanceyeg

jwick

Are you letting it cool properly prior to killing the ignition?

__________________
'10 G37T 6MT Graphite/Graphite - BP - G37T Build

Cell

Just drive easy for a couple minutes before you get home.

TopgunZ

I am. Even if i wasn't, I never heard the noise until after the turbo blanket install.

I drive really slow through my neighborhood, pretty much at idle since im on a slant, which takes a minute at least. But again, I did this same thing without the blanket and never once heard the oil boiling. As soon as i put it on I noticed it that same day.

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

jwick

Why would a setup like this have any left over oil in the turbo. Shouldn't gravity drain it all back to the pan?

__________________
'10 G37T 6MT Graphite/Graphite - BP - G37T Build

TopgunZ

Im not sure. Maybe it could have been coolant burning too since it is coolant and oil cooled. Or whatever doesn't drain out, whats left along the sides, just boils.

__________________
ROTREX SUPERCHARGER TUNER KITS - $6799/ CUSTOM STILLEN AIR TO AIR KITS -$2100/ 700+ WHP!! WWW.TOPGUNSPEEDWORKS.COM

AdobePhil

Bobby is putting this kit on for me next Monday at the shop. Already put the deposit down. I'll post the Dyne charts and vids here for you if you're still considering it.

__________________
2010 370z Sport Trim / Anodized Racing Pedals / Injen CAI / Invidia Exhaust / Kinetix HFCs/ AEM 320ml Fuel Pump / Upgraded fuel lines and rails / Deutchwerks 850cc Fuel Injectors / Zex Nitrous / Uprev Tuned / /330whp N/A/452whp Nitrous

COSMO

Hey man while your there see if you can snap some pics of my motor they are building for me...

AdobePhil

Not a problem. Wish I'd posted yesterday as I was at the shop for about 5 hours getting my oil cooler reattached after my own new engine drop.

Does bobby know your alias on this site or do you want to pm me your name?

__________________
2010 370z Sport Trim / Anodized Racing Pedals / Injen CAI / Invidia Exhaust / Kinetix HFCs/ AEM 320ml Fuel Pump / Upgraded fuel lines and rails / Deutchwerks 850cc Fuel Injectors / Zex Nitrous / Uprev Tuned / /330whp N/A/452whp Nitrous

COSMO

He knows my name on here.. Oh and thanks!

dc3843

Yes please!

xxAGAVExx

Subd for results


Sent from my iPhone using Tapatalk

__________________
l 09/6MT l BP Twin Turbo Kit l E-85 w/Fuel Return l FI 18" Res CF CBE l Powertrix Ultra-Lite Coilovers l Wavetrac LSD | Lots of SPL and Carbon Fiber |

critical

1ST 7AT TOP MOUNT TURBO BUILD.. By S&R Performance

I need Low miles Vq37vhr ASAP.

__________________
Quaife w/ gears |Stillen Gen 3|SOLD FI Resonated Test Pipes |SOLD FI 18'' | 25row Stillen Race | Progress 35mm/25mm sways | Swifts/Koni|Volk G25's| Stoptech SS lines||SPL Front/Rear Arms|