Nissan 370Z Forum
Page 101 of 192 « First 519199100 101 102103111151 Last »
Show 40 post(s) from this thread on one page

Nissan 370Z Forum (http://www.the370z.com/)
-   Forced Induction (http://www.the370z.com/forced-induction/)
-   -   GTM Performance Engineering: MHI Twin Turbo Official Release (http://www.the370z.com/forced-induction/68491-gtm-performance-engineering-mhi-twin-turbo-official-release.html)

m3chhawk 09-19-2013 11:04 PM
Boosted will always be the easiest to install, but he will probably be last to market with a G kit as well.

Dzel 09-20-2013 04:34 AM
^ I totally agree:thumbup:

Sent with TapAhoe

Dzel 09-20-2013 04:39 AM
Spohn I'm running the same numbers as you in the exhaust department that is. I have a Beluga 2.75 CBE but my CNT TP'S and my flanges are 2.5. Would it make that much more difference if I went 2.75 all the way through?

Sent with TapAhoe

Alstann 09-20-2013 07:27 AM
Quote:
Originally Posted by SPOHN (Post 2496378)
This is my boat also. I have the Greddy TI-C which is 2.75 (70mm) but to me looks to taper to a 2.5 where it would bolt up. I'll measure tomorrow. So while doing this I'm going to have the resonators taken out for a true straight pipe.
Mmhmm. I'm debating back and forth between doing an electric cutout, since I want my car to be daily driveable, and that I believe that if I have a 3 inch cutout, I might be able to make some nice gains.

Worst case, FI 3 inch. :tup:

Quote:
Originally Posted by Dzel (Post 2496637)
Spohn I'm running the same numbers as you in the exhaust department that is. I have a Beluga 2.75 CBE but my CNT TP'S and my flanges are 2.5. Would it make that much more difference if I went 2.75 all the way through?

Sent with TapAhoe
From my personal knowledge with fluid mechanics, it'll make a noticeable difference. You'll be creating less room for weird counterflow or pressure changes/drops if you make it a straight 2.75 system, rather than having the system taper hard to 2.5 at one point.

Dzel 09-20-2013 09:46 AM
I'm all about higher hp numbers with less boost!

Sent with TapAhoe

Chuck33079 09-20-2013 10:12 AM
Quote:
Originally Posted by Alstann (Post 2496726)
Worst case, FI 3 inch. :tup:
That's the best case scenario, not the worst case.

SPOHN 09-20-2013 10:33 AM
Quote:
Originally Posted by Dzel (Post 2496926)
I'm all about higher hp numbers with less boost!

Sent with TapAhoe
If this is the case port and polish the turbos.

Dzel 09-20-2013 10:44 AM
Quote:
Originally Posted by SPOHN (Post 2497077)
If this is the case port and polish the turbos.
We do not all have deep pockets Spohn a.k.a. Ballin out of control!:bowrofl:

Alstann 09-20-2013 11:51 AM
Quote:
Originally Posted by elperuano (Post 2496312)
What part of FL r u in? When this is done I'd like to check out the setup and then run it!
I'm in Boca Raton man! I'm dying to get the kit, my car has been on jackstands for almost 3 months now. Meeting fellow Z owners is always nice :tiphat:

elperuano 09-20-2013 12:20 PM
Quote:
Originally Posted by Alstann (Post 2497246)
I'm in Boca Raton man! I'm dying to get the kit, my car has been on jackstands for almost 3 months now. Meeting fellow Z owners is always nice :tiphat:
That's cool man. I'm in sunrise. Definitely wanna check out the ride when all said n done. Lemme know if u go to any of the meets around this area.

Infidel 09-20-2013 01:24 PM
Quote:
Originally Posted by elperuano (Post 2497282)
That's cool man. I'm in sunrise. Definitely wanna check out the ride when all said n done. Lemme know if u go to any of the meets around this area.
Looks like I'm just west of you a few miles on 50. I should be getting my kit installed by Z1 Performance when it gets to me...gonna be a loooong trip to Georgia. Spoke to him today for a while. I sorta regret not getting the SC that I was talked out of (thanks Andrew:shakes head:) but it's too late now.

elperuano 09-20-2013 02:31 PM
Quote:
Originally Posted by Infidel (Post 2497399)
Looks like I'm just west of you a few miles on 50. I should be getting my kit installed by Z1 Performance when it gets to me...gonna be a loooong trip to Georgia. Spoke to him today for a while. I sorta regret not getting the SC that I was talked out of (thanks Andrew:shakes head:) but it's too late now.
I took the same trip for my tune. Was a loooong drive and even more frustrating keeping my foot from mashing the pedal but Jon is the man tuning these cars. Well worth it buddy.

zguynate 09-21-2013 12:06 PM
I was able to squeeze in on this. Im super excited!! Hopefully by the time I pay off my layaway amount, these will be on the shelves ready to ship.

I still have to finish my s13 which is literally completely disassembled getting ready for paint before I start sending money for this kit. Im hoping around April. Until then, Ill be anxiously waiting for you guys to post threads and videos and drool lol.

Alstann 09-22-2013 07:35 AM
Week's end already?

-sadface-

SPOHN 09-22-2013 01:14 PM
Quote:
Originally Posted by Alstann (Post 2499446)
Week's end already?

-sadface-
Must be next week.:ugh2:


All times are GMT -5. The time now is 12:44 AM.
Page 101 of 192 « First 519199100 101 102103111151 Last »
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2